Design and Implementation of IOT-Based Intravenous (IV) Bag Monitoring and Alert System
- Authors
-
-
Gregory T. AKAU
Department of Electrical/Electronics, Nigerian Defence Academy, Kaduna, Nigeria
Author
-
Abel AIROBOMAN
Department of Electrical/Electronics, Nigerian Defence Academy, Kaduna, Nigeria
Author
-
Nathaniel DALLA
Department of Electrical/Electronics, Nigerian Defence Academy, Kaduna, Nigeria
Author
-
- Keywords:
- Intravenous (IV) monitoring, IoT-based healthcare, Arduino Uno, drip rate monitoring, ESP8266 Wi-Fi, ThingSpeak cloud, hospital automation.
- Abstract
-
Health, being a critical aspect of daily life, demands heightened attention, especially when a patient is hospitalized. In densely populated hospitals with limited nursing staff, the continuous monitoring of Intravenous (IV) fluid becomes a challenge. If the IV fluid is not properly monitored, severe consequences may arise, such as blood reflux or the entry of air bubbles into the patient's bloodstream when the fluid bottle runs dry. To address this, the project proposes the design and implementation of an IoT-based intravenous infusion monitoring and Alert System using the Huamao Communication 12 radio frequency module (HC-12) for wireless communication. The system also integrates Espressif Wi-Fi SoC ESP8266 wi-fi connectivity for real-time data transmission to the ThinkSpeak cloud platform. The hardware setup includes a load cell with an HX711 interface for continuous measurement of the IV fluid's weight, and a laser sensor positioned on the drip chamber to monitor the droplet rate. An Arduino Uno microcontroller coordinates the sensors and decision logic. When the fluid level drops below a critical threshold or the drip rate becomes abnormal, an alert is transmitted wirelessly via the RF module to a remote receiver unit (e.g., nurse’s station), where the patient's information and alert status are displayed. Additionally, the ESP8266 module uploads real-time data to the internet for remote monitoring and analytics. The performance evaluation of the prototype demonstrated a system success rate of approximately 96.8% in accurately detecting both low-fluid and abnormal drip rates. This low-cost, easily deployable system enhances patient safety by ensuring timely intervention from medical staff and is particularly suited for resource-constrained hospitals that cannot afford expensive commercial IV monitoring system.
- References
- Downloads
- Published
- 15-11-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Nnamdi S. OKOMBA, Adedayo A. SOBOWALE, Adebimpe O. ESAN, Bolaji A. OMODUNBI, Taiwo A. AWOYEMI, Development of an Intelligent-Based Elevator System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Peter S. IDOKO, Iyinoluwa T. IDOWU, Emmanuel O. AYODELE, Temitope F. SHOLANKE, Peter A. IDOWU, Machine Learning Based Feature Selection for Early Detection of Thyroid Disorders in Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- James AUDU, Abdulraman A. SALAWU, Muriana R. AREMU, Abdullahi A. ALHAJI, Lawal S. SIUS, Characterisation of Pumice-Kaolin Refractory Bricks for High Temperature Industrial Applications , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Vincent B. ONIGBARA, Sunday I. AGU, Muftau A. GBENLE, Metal-Based Biomaterials for Clinical Implant Applications: Materials and Performance – A Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Paramdi S. ABARI, Abdulwahab O. AUDU, Ahmad-Tijani USMAN, Charity T. METIBOBA, Peter O. ANIKOH, Performance Evaluation and Design Analysis of Hybrid Constructed Wetlands for Aquaculture Effluent Treatment under Tropical Conditions , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Kingsley C. IGWE, Abubakar T. MUHAMMAD, Obiseye OBIYEMI, Abiodun S. MOSES, Aku G. IBRAHIM, Joel A. EZENWORA, Julia O. EICHIE, Real-Time Evaluation of Rain-Induced Signal Degradation on Digital Satellite Television Links in Minna, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muyideen O. MOMOH, Emmanuel I. AWODE, Gowon SULE, Umar ABUBAKAR, Ikechukwu O. ALUM, Usman K. AMINU, Bio-Inspired Flight Mechanisms for Unmanned Aerial Vehicles: An Overview , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Oluwayinka. G. AKINWAMIDE, Olugbenga O. AMU, Christopher FAPOHUNDA, Prediction of International Roughness Index of Flexible Pavement Using Machine Learning-Based Predictive Framework in Ekiti State , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Abimbola J. KOLAWOLE, AbdulKodri G. ABDULRAFIU, An Evaluation of the Challenges and Limitations in the Adoption of Technological Innovations at Nnamdi Azikiwe International Airport , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Mohammed U. GARBA, Usman B. ABDULLAHI, Hayatudden S. BARAYAIS, Aisha B. FARUQ, Suleiman IDRIS, Abubakar M. MUHAMMAD, Abubakar S. MOHAMMED, Treatment of Gold Mining Wastewater: A Review of Current Technologies and Future Perspectives , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
