Software-in-the-Loop Validation of an Adaptive Particle Swarm Optimization-Based MPPT Controller for Real-Time Photovoltaic System
- Authors
-
-
Emmanuel T. ODEYEMI
Author
-
Ya’u S. HARUNA
Author
-
Ganiyu A. BAKARE
Author
-
Hassan B. MAMMAN
Author
-
Sabo M. HASSAN
Author
-
- Keywords:
- Adaptive Particle Swarm Optimization, Maximum Power Point Tracking, Software-in-the-Loop, Solar Photovoltaic Systems, and Dynamic Irradiance.
- Abstract
-
Maximum Power Point Tracking (MPPT) is essential for maximizing energy yield in photovoltaic (PV) systems under dynamic environmental conditions. This study presents a comparative evaluation and real-time Software-in-the-Loop (SIL) validation of conventional and intelligent MPPT algorithms for a 1.5 MW standalone PV system, representing a utility-scale installation with high current and dynamic complexity. The Adaptive Particle Swarm Optimization (APSO) algorithm is characterized by dynamic adjustments of inertia weight and acceleration coefficients, enhancing convergence speed and tracking accuracy. A high-fidelity MATLAB/Simulink model, integrating a DC–DC boost converter and dynamic irradiance profiles, was developed. P&O, INC, GA, and APSO were evaluated based on tracking efficiency, convergence speed, and steady-state ripple. The results show that APSO achieved the highest tracking efficiency (99.3%), the fastest convergence (0.8 s), and the lowest ripple (1.8%), outperforming GA, P&O, and INC. SIL validation further confirmed the feasibility and robustness of APSO, maintaining 99.0% efficiency and 1.6% ripple under real-time constraints. These findings establish APSO as a reliable, implementation-ready MPPT solution for large-scale PV systems.
- References
- Downloads
- Published
- 23-05-2026
- Section
- Articles
- License
-
Copyright (c) 2026 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Emmanuel T. ODEYEMI, Ya’u S. HARUNA, Ganiyu A. BAKARE, Hassan B. MAMMAN, Sabo M. HASSAN, BAT-Optimized PID and ANFIS Torque-Based MPPT for a 0.5 MW PMSG-Based Wind Energy Conversion System Under Dynamic Wind Conditions , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Mela I. L. LASHIRU, Ganiyu A. BAKARE, Sabo M. HASSAN, Kamilu O. LAWAL, Data-Driven Observability Enhancement in Active Distribution Networks via Optimal Co-Deployment of DGs and D-PMUs Using Hybrid APSO-ASDA , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Hafsah A. ABDULRAHMAN, Muhammad M. HAMIDU, Techno-Economic Optimization of a Hybrid PV-Wind-Waste-to Energy System for the University of Maiduguri , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammad M. HAMIDU, Mathew KATAMBI, Omar FARUQ, Techno-Economic and Environmental Assessment of a Solar PV-Based Microgrid for Residential Electrification in Gwange I, Maiduguri Using HOMER Pro , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Habib I. ABDULAZEEZ, Bala ABDULLAHI, Abdullahi AHMED, Ibrahim A. TUKUR, Experimental Investigation of Solar Photovoltaic Tilt Angles for Maximum Energy Harvest in Kogi State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Aminu BALA, Nasiru B. KADANDANI, Isiyaku ABUBAKAR, Performance Evaluation of Fuzzy Logic and Fractional Order PI Controllers for Electric Vehicle Wireless Charging System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Ismaila MAHMUD, Mahmud MUSTAPHA, Sulaiman H. SULAIMAN, Ibrahim ABDULWAHAB, Ibrahim A. SHEHU, Aminu J. ALIYU, Yusuf S. ABU, Nuraddeen A. ILIYASU, Solar Irradiance Forecast using Feed Forward Neural Network: A Case Study of Zaria Town , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammad M. HAMIDU, Development of MATLAB-Based Model for Solar Radiation Prediction and Photovoltaic Panel Tilt Optimization Angle for Maiduguri Region, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Zaharaddeen MUSA, Aliyu BELLO, Haris A. DANLADI, Design and Construction of Dual Input Mobile Solar Generator for Reliable Off-Grid Power , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Ibrahim M. GANA, Abdullahi YUSUF, Agidi GBABO, Micheal EPHRAIM, Abubakar M. HASSAN, Development and Testing of an Automated Solar-Powered Nutrient Film Technique (NFT) Hydroponic Planting System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Mela I. L. LASHIRU, Ganiyu A. BAKARE, Sabo M. HASSAN, Kamilu O. LAWAL, Data-Driven Observability Enhancement in Active Distribution Networks via Optimal Co-Deployment of DGs and D-PMUs Using Hybrid APSO-ASDA , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Emmanuel T. ODEYEMI, Ya’u S. HARUNA, Ganiyu A. BAKARE, Hassan B. MAMMAN, Sabo M. HASSAN, BAT-Optimized PID and ANFIS Torque-Based MPPT for a 0.5 MW PMSG-Based Wind Energy Conversion System Under Dynamic Wind Conditions , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
