Evaluation on the Rheological Properties of Water-Based Drilling Mud: A Case Study of Ire-Ekiti Clay
- Authors
-
-
Joseph O. AJAYI
Author
-
Adekunle T. ADENIYI
Author
-
Mufliah G. OMOFOYEWA
Author
-
Abel A. ADEYI
Author
-
Abdulwahab GIWA
Author
-
- Keywords:
- Ire-Ekiti clay, beneficiation, bentonite, rheological properties, water-based mud.
- Abstract
-
Rheological properties are tested throughout a drilling operation as it is critical in the control and maintenance of rheological properties. This paper investigates the evaluation on the Marsh funnel viscosity, apparent viscosity, and fluid loss of water-based drilling mud. The native clay originated in Ire-Ekiti, Ekiti State, Nigeria. In order to create water-based mud, the characteristics of the clay were determined and compared with those of bentonite, the preferred clay for drilling operations. The results show that the generated drilling fluid's pH levels and rheological characteristics differ significantly from bentonite. This is due to the fact that it attracts clay and water, and the low concentration of sodium cations (Na++) prevents it from swelling. When the local mud was beneficiated using soda ash (Na2CO3) at a concentration of 5.0 g clay at 63 microns screen size to 350 ml of the mud, the pH rose by 15.2% from 8.11 to 11.02 and by 8% from 10.00 to 11.73. When PAC-HV was added to the combination, water loss significantly decreased by 32.8% and 66.8%, while marsh funnel viscosity increased by 4.4% and 7.6%, apparent viscosity fell by 26.6% at 63 microns sieve size, and severely rose by 55.8% at 150 microns filter size. After adding 10 g of barite (BaSO4) to 350 ml of the mixture, the clay density rose by 1.2% at both sieve sizes, from 8.50 lb/gal to 8.70 lb/gal. Therefore, the Ire clay has good rheological properties at substantial concentrations when beneficiated with soda ash (Na2CO3), which would compare favorably with those of bentonite; however, PAC-HV must be increased above 1.0 g at 150 microns filter size. Ire clay can therefore be used to make a drilling fluid.
- References
- Downloads
- Published
- 09-05-2026
- Section
- Articles
- License
-
Copyright (c) 2026 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Hillary T. OGBODO, Bilkisu L. MUHAMMAD-BELLO, Joshua ABAH, Saleh E.-Y. ABDULLAHI, Quantum Computing Applications in Software Engineering: A Scoping Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Paramdi S. ABARI, Abdulwahab O. AUDU, Ahmad-Tijani USMAN, Charity T. METIBOBA, Peter O. ANIKOH, Performance Evaluation and Design Analysis of Hybrid Constructed Wetlands for Aquaculture Effluent Treatment under Tropical Conditions , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Chibuzor A. OKAFOR, Bello ABDULKAREEM, Najeem A. YEKEEN, Blessing A. OSULOYE, Yakubu O. HASSAN, Musa J. MAIKATO, Evaluation of the Effects of Charcoal Particle Sizes on Carburized Low Carbon Steel , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammed A. ADAWUDI, Danlami MALIKI, Ibrahim M. ABDULLAHI, Electric Fish Optimizer-Based Hyperparameter Tuning of MLP for Fault Diagnosis in Grid-Connected Photovoltaic Systems , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Nnamdi S. OKOMBA, Adedayo A. SOBOWALE, Adebimpe O. ESAN, Bolaji A. OMODUNBI, Taiwo A. AWOYEMI, Development of an Intelligent-Based Elevator System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Ismaila MAHMUD, Mahmud MUSTAPHA, Sulaiman H. SULAIMAN, Ibrahim ABDULWAHAB, Ibrahim A. SHEHU, Aminu J. ALIYU, Yusuf S. ABU, Nuraddeen A. ILIYASU, Solar Irradiance Forecast using Feed Forward Neural Network: A Case Study of Zaria Town , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Babagoni A. ADAM, Muhammad B. MAINA, Muhammad SHUWA, Abba B. MUHAMMAD, A Review on Neem Leaves Valorization Through Advanced Briquetting and Carbonization Technologies , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Idris M. WADA, Abba IBRAHIM, Genesis ISHAYA, Performance Evaluation of Climate Products with Validation Using Bootstrapping and Climate Extremes in the Hadejia-Jama’are River Basin, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammad M. HAMIDU, Mathew KATAMBI, Omar FARUQ, Techno-Economic and Environmental Assessment of a Solar PV-Based Microgrid for Residential Electrification in Gwange I, Maiduguri Using HOMER Pro , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Bala I. ABDULKARIM, Yusuf M. BABA, Suleiman I. ENEHE, Kamoru A. SALAM, Umar IDRISS, Synthesis of Activated Carbon from Corncob for the removal of Lead (Pb²⁺) ions from Aqueous solution using a packed bed Adsorption Column , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Salisu MOHAMMED, Abdulfatai JIMOH, Abdullahi M. EVUTI, Abdulwahab GIWA, Abubakar A. IBRAHIM, Pretreatment and Characterization of Selected Precursors for Chitin/Chitosan Production , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Ephraim G. KEFAS, Abdulfatai JIMOH, Mohammed A. EVUTI, Abubakar A. IBRAHIM, Abdulwahab GIWA, Adeola G. OLUGBENGA, Luffa Sponge, Banana Stem and Delonix regia Seed Characterization as Potential Biosorbents for Industrial Wastewater Remediation , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Hyelni G. MSHELIA, Abdulfatai JIMOH, Mohammed A. EVUTI, Abubakar A. IBRAHIM, Abdulwahab GIWA, Adeola G. OLUGBENGA, Potential of Onion Skin, Luffa cylindrica, and Corn Cob as Cellulose Sources: A Study of Their Proximate, Ultimate, and Morphological Properties , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
