Utilization of Microbial Fuel Cells for Electricity Generation from Gwagwalada Abattoir Wastewater
- Authors
-
-
Bala I. ABDULKARIM
Department of Chemical Engineering, University of Abuja, Abuja, Nigeria
Author
-
Phebe O. JAMES
Department of Chemical Engineering, University of Abuja, Abuja, Nigeria
Author
-
- Keywords:
- Electricity generation, microbial fuel cells, abattoir wastewater, total dissolved solids, pH.
- Abstract
-
This study explores the use of microbial fuel cells (MFCs) for electricity generation and wastewater treatment using wastewater from the Gwagwalada abattoir. The research aimed to assess contamination levels, develop an MFC system, and evaluate its performance over 240 hours. Key parameters analysed are: Biochemical Oxygen Demand (BOD), Chemical Oxygen Demand (COD), Total Dissolved Solids (TDS), Total Suspended Solids (TSS), conductivity, and pH, before and after treatment. The MFC was constructed based on established designs and its electrical output voltage and current was monitored throughout the experiment. Results showed a significant reduction in BOD and COD by 69.8% and 68.8%, respectively. The MFC also produced a maximum voltage of 94 mV and current of 0.2 mA. These findings demonstrate that MFCs can simultaneously treat abattoir wastewater and generate electricity, suggesting a promising avenue for sustainable waste-to-energy technologies with potential for further enhancement.
- References
- Downloads
- Published
- 01-09-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Joseph K. ZAMBWA, Jibril M. KAURA, Ocholi AMANA, Abdrasheed S. ABDURASHEED, Ejembi WILLIAMA, Evaluation of Materials and Performance Characteristics of Tannery Sludge Crumb Rubber Concrete (TSCRC) , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Ahmad ADO, Abdullahi YAHAYA, Abubakar J. MUHAMMAD, Zaharaddeen G. SANI, Baba A. OLUWA, Abdulazeez A. YUSUF, Kinetic Study of 4-Nitrophenol Sonocatalytic Degradation , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Hafsa K. AHMAD, Graph-Augmented Transformers for Hausa Sentiment Analysis: When Does Graph Structure Help? , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Muhammad M. HAMIDU, Development of MATLAB-Based Model for Solar Radiation Prediction and Photovoltaic Panel Tilt Optimization Angle for Maiduguri Region, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Zakariah A. ADEJOH, Hawawu SALAMI, Abdullahi M. EVUTI, Yahaya S. MOHAMMAD, Yakubu STEPHEN, Effect of Activation Time on Physicochemical Properties of Activated Carbon Prepared from Coconut Shell , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Oluwayinka. G. AKINWAMIDE, Olugbenga O. AMU, Christopher FAPOHUNDA, Prediction of International Roughness Index of Flexible Pavement Using Machine Learning-Based Predictive Framework in Ekiti State , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Habib I. ABDULAZEEZ, Bala ABDULLAHI, Abdullahi AHMED, Ibrahim A. TUKUR, Experimental Investigation of Solar Photovoltaic Tilt Angles for Maximum Energy Harvest in Kogi State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Abdulrasheed MUSTAPHA, Kolawole O. MORAKINYO, Seyi O. FARODOYE, Rilwan B. HABEEB, Oluwatimilehin I. ADEBAMBO, Sunday F. OLAWALE, Evaluation of Green Architectural Strategies for Thermal Comfort in Four-Star Hotels in Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Joseph A. OJENIYI, Zainab L. BELLO, Ismail IDRIS, Noel M. DOGONYARO, Suleiman AHMAD, Sikiru O. SUBAIRU, Entropy-Based Deep Learning Framework for Classifying Ransomware Families in Windows Environment , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Emmanuel T. ODEYEMI, Ya’u S. HARUNA, Ganiyu A. BAKARE, Hassan B. MAMMAN, Sabo M. HASSAN, Software-in-the-Loop Validation of an Adaptive Particle Swarm Optimization-Based MPPT Controller for Real-Time Photovoltaic System , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Bala I. ABDULKARIM, Yusuf M. BABA, Suleiman I. ENEHE, Kamoru A. SALAM, Umar IDRISS, Synthesis of Activated Carbon from Corncob for the removal of Lead (Pb²⁺) ions from Aqueous solution using a packed bed Adsorption Column , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Bala I. ABDULKARIM, Umar IDRISS, Synthesis and Characterization of Laggera aurita-Derived KOH Activated Carbon (LAKOHAC) and Role for the Adsorption of Water-Soluble Fraction of Benzene (WSFB) in Oil-Spilled Water , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
