Utilization of Microbial Fuel Cells for Electricity Generation from Gwagwalada Abattoir Wastewater
- Authors
-
-
Bala I. ABDULKARIM
Department of Chemical Engineering, University of Abuja, Abuja, Nigeria
Author
-
Phebe O. JAMES
Department of Chemical Engineering, University of Abuja, Abuja, Nigeria
Author
-
- Keywords:
- Electricity generation, microbial fuel cells, abattoir wastewater, total dissolved solids, pH.
- Abstract
-
This study explores the use of microbial fuel cells (MFCs) for electricity generation and wastewater treatment using wastewater from the Gwagwalada abattoir. The research aimed to assess contamination levels, develop an MFC system, and evaluate its performance over 240 hours. Key parameters analysed are: Biochemical Oxygen Demand (BOD), Chemical Oxygen Demand (COD), Total Dissolved Solids (TDS), Total Suspended Solids (TSS), conductivity, and pH, before and after treatment. The MFC was constructed based on established designs and its electrical output voltage and current was monitored throughout the experiment. Results showed a significant reduction in BOD and COD by 69.8% and 68.8%, respectively. The MFC also produced a maximum voltage of 94 mV and current of 0.2 mA. These findings demonstrate that MFCs can simultaneously treat abattoir wastewater and generate electricity, suggesting a promising avenue for sustainable waste-to-energy technologies with potential for further enhancement.
- References
- Downloads
- Published
- 01-09-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Temitope E. OLUBODUN, Joshua T. AKINWAMIDE, Olugbenga O. AMU, Characterization of Shear Strength Parameters for Construction Works in Ado-Ekiti Metropolis, Ekiti State, Southwestern Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Idris M. WADA, Abba IBRAHIM, Genesis ISHAYA, Performance Evaluation of Climate Products with Validation Using Bootstrapping and Climate Extremes in the Hadejia-Jama’are River Basin, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Johnson O. ADEOGO, Examination of Electromagnetic Radiation Intensity of 5G Mobile Transceivers Based on Its Operational Techniques , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Muhammad M. ABDULLAHI, Iyanda M. ANIMASHAUN, Ibrahim A. ABDULFATAI, George U. STEPHEN, Spatial Scale Effects on the Relationship Between Land Use/Land Cover Change and Potential Evapotranspiration in Niger State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Abdulkareem BELLO, Saleh S. LUKMAN, Tasie M. CHIZE, Yusuf O. ADEIZA, Chibuzor A. OKAFOR, Abdullahi O. YAKUBU, Design, Simulation, and 3D Printing of a Lightweight Drone Frame for Farm Monitoring , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Osagie I. IHENYEN, Raymond A. EKEMUBE, Development of an Agro-Waste Diesel Engine Powered Shredding Machine , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Michael R. ADU, Blessing O. UMUKORO, Design and Construction of a 1.5 kVA Pure Sine Wave Inverter for Office Use , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- John O. NWODO, Toyin Y. AKANBI, Hassan K. ABDULRASHEED, Experimental Analysis of Early Compressive Strength of Sandcrete Block Blended with Rice Husk Ash and Activated with Soda Ash , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Mohammed B. ABDULLAHI, Impact of Agro-Chemicals on Groundwater Quality and Soils of Irrigation Sites: A Case Study of Chanchaga Irrigation Scheme, Minna, Niger State , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Olusiji A. ADEYANJU, Joseph O. OLAIDE, Machine Learning Models for Predicting Flow Rate for Niger Delta Oil Wells , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Bala I. ABDULKARIM, Yusuf M. BABA, Suleiman I. ENEHE, Kamoru A. SALAM, Umar IDRISS, Synthesis of Activated Carbon from Corncob for the removal of Lead (Pb²⁺) ions from Aqueous solution using a packed bed Adsorption Column , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Bala I. ABDULKARIM, Umar IDRISS, Synthesis and Characterization of Laggera aurita-Derived KOH Activated Carbon (LAKOHAC) and Role for the Adsorption of Water-Soluble Fraction of Benzene (WSFB) in Oil-Spilled Water , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
