Experimental Investigation of Solar Photovoltaic Tilt Angles for Maximum Energy Harvest in Kogi State, Nigeria
- Authors
-
-
Habib I. ABDULAZEEZ
Rural Electrification Agency (REA), Abuja, Nigeria
Author
-
Bala ABDULLAHI
Department of Mechanical Engineering, Aliko Dangote University of Science and Technology, Wudil, Kano State, Nigeria
Author
-
Abdullahi AHMED
Department of Mechanical Engineering, Aliko Dangote University of Science and Technology Wudil, Kano State, Nigeria
Author
-
Ibrahim A. TUKUR
Department of Mechanical Engineering, Aliko Dangote University of Science and Technology, Wudil, Kano State, Nigeria
Author
-
- Keywords:
- Solar photovoltaic (PV) panels, tilt angle optimization, solar radiation, Kogi State, Nigeria.
- Abstract
-
This study aimed to investigate the impact of tilt angles on solar radiation, current, voltage, and power output of a photovoltaic system, while also employing mathematical modeling to predict solar radiation. This study experimentally investigates the effect of tilt angle (0°, 7.8°, 22.8°, 37.8°, and 52.8°) on the performance of 10W polycrystalline solar panels in Kogi State, Nigeria, over a 12-month period (November 2023–October 2024). Solar radiation, current, and power output were measured at 20-minute intervals using data loggers, voltmeters, and ammeters. The study only investigates the effect of tilt angle and does not consider other factors that may impact solar panel efficiency, such as dust accumulation, temperature, or shading. Results show that optimal performance varies seasonally: lower angles (0°–7.8°) yielded higher radiation and power during peak dry seasons (e.g., November, 613.67 W/m² at 22.8°), while steeper angles (22.8°–37.8°) performed better in transitional months. The 7.8° tilt achieved the highest yearly average radiation, whereas the 0° tilt produced the highest average current (0.300 A) and power (4.51 W). These findings suggest that adjusting tilt angles seasonally can maximize solar energy efficiency in Kogi State, with 7.8° recommended as the best annual fixed tilt.
- References
- Downloads
- Published
- 08-08-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Abdulkareem BELLO, Saleh S. LUKMAN, Tasie M. CHIZE, Yusuf O. ADEIZA, Chibuzor A. OKAFOR, Abdullahi O. YAKUBU, Design, Simulation, and 3D Printing of a Lightweight Drone Frame for Farm Monitoring , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Ayodele S. OLUWOLE, Olumayowa A. OJO, Olaitan AKINSANMI, Model Selection for Path Loss Prediction of Ultra High Frequency Terrestrial Television , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Ahmad IDRIS, Evaluation of Challawa Tannery Wastewater as Mixing and Curing Water for Concrete Production , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Shehu S. SHEHU, Samuel O. OLADIPUPO, Dominic S. NYITAMEN, Simulation and Performance Analysis of a Military Insignia Microstrip Patch Antenna at 2.45 GHz For Wireless Applications , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Joseph O. AJAYI, Adekunle T. ADENIYI, Mufliah G. OMOFOYEWA, Abel A. ADEYI, Abdulwahab GIWA, Evaluation on the Rheological Properties of Water-Based Drilling Mud: A Case Study of Ire-Ekiti Clay , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Hammed A. OLASUNKANMI, Olumuyiwa I. ADENIJI, Mufutau K. LAWAL, Babatola E. OJO, Babayemi D. OMOWOLE, Somtochukwu E. AVAH, Isiaka A. ADELEKE, Kudirat N. POPOOLA, Ademidun E. IBITOYE, Design and Implementation of a Secure AI-Based Product Showcase and Customer Support System for Small and Medium-Sized Enterprises , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Peter EDOKA, Incidents of Flood Disaster in Kaduna: Preventive and Mitigating Measures , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Paramdi S. ABARI, Abdulwahab O. AUDU, Ahmad-Tijani USMAN, Charity T. METIBOBA, Peter O. ANIKOH, Performance Evaluation and Design Analysis of Hybrid Constructed Wetlands for Aquaculture Effluent Treatment under Tropical Conditions , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Nuhu MOHAMMED, Garkuwa Y. ADAMU, Abubakar A. FACHWAY, Aminu MOHAMMED, Afolayan A. OLASUNKANMI, Odoh F. CHIMEZIE, Muhammad A. YUSUF, Development of A Water-Recycling Pico Hydropower System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Bala YAHAYA, Characterization of Soil Quality Parameters in Sector 2 of Watari Irrigation Project, Kano , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
You may also start an advanced similarity search for this article.
