Decline Curve Analysis of Continuous Injection Gas Lifted Wells
- Authors
-
-
Ayodele DANIEL
Author
-
Mercy O. AKEJU
Author
-
Sunday O. ISEHUNWA
Author
-
Abel A. ADEYI
Author
-
Adebayo T. OGUNYEMI
Author
-
- Keywords:
- Decline curve analysis, Developed reserves, Production rate, Gas lift, Arps’ exponential model.
- Abstract
-
Decline Curve Analysis is one of the established techniques for reservoir performance evaluation and estimation of developed reserves. While it has been well utilized for natural drive production, there have been challenges in accurate evaluation of gas lifted wells because of additional energy that supplements the natural which changes future production rate of the reservoir and distorts the reservoir’s production decline trend. For continuous gas lifted wells, several attempts have been made to model production rates, but none have been found to be simple or accurate. In this article the principle of superposition has been applied such that the production rate of a well at a time, t after gas-lift has been introduced would be the sum of the flow rate due to the natural flow and gas-lift induced flow rate. Four actual well production data sets obtained from the SPE Data Repository and from reservoirs in literature from Niger Delta were used to assess the model. The analysis done included cases with and without gas lift and statistical analysis was done to evaluate the error margin. The equation derived is a mathematical model in which the traditional Arps’ exponential model accounts for the natural flow and a power law model accounts for the gas-lift induced flow expressed as:
q_t=q_inf 〖[e〗^(-Dt)+βt^(-λD)]
The model proposed showed that 0.48MMstb, 0.31MMstb, 8.75MMstb, and 1.23MMstb respectively would be produced when gas-lift is introduced as opposed to 0.26MMstb, 0.16MMstb, 7.96MMstb, and 1.10MMstb without gas-lift respectively, from well 1 to 4. The model also predicted future rates that were similar to the actual field data with correlation coefficient of 0.884, 0.806, 0.917, and 0.874 respectively. This statistical result indicates the effectiveness of the model in predicting the production decline rate of gas-lifted wells.
- References
- Downloads
- Published
- 29-08-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Ayodele DANIEL, Mercy O. AKEJU, Sunday O. ISEHUNWA, Abel A. ADEYI, Adebayo T. OGUNYEMI (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Muhammad M. ABDULLAHI, Iyanda M. ANIMASHAUN, Ibrahim A. ABDULFATAI, George U. STEPHEN, Spatial Scale Effects on the Relationship Between Land Use/Land Cover Change and Potential Evapotranspiration in Niger State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Kazeem A. BELLO, Adeniyi O. ADESINA, Lukman A. OPEYEMI, Solomon O. UVIASE, The Impact of Industry 4.0 on New Product Development in Small and Medium Enterprises: A Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Victor A. NSABA, Sabiu B. YUSUF, Kafayat A. IBRAHIM, Consumer Perceptions of Artificial Intelligence (AI)-Driven Smart Grids and Energy Efficiency in Northwest Nigeria’s Power Distribution Sector: A Multi-State Case Study of Sokoto, Kebbi, and Zamfara , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Peter S. IDOKO, Iyinoluwa T. IDOWU, Emmanuel O. AYODELE, Temitope F. SHOLANKE, Peter A. IDOWU, Machine Learning Based Feature Selection for Early Detection of Thyroid Disorders in Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Osagie I. IHENYEN, Raymond A. EKEMUBE, Development of an Agro-Waste Diesel Engine Powered Shredding Machine , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Murtala ISMAIL, Mohammed S. ISMAIL, Eli A. JIYA, Machine Learning-Driven Recruitment Recommendation System for Employment in Nigerian Universities , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Bala YAHAYA, Characterization of Soil Quality Parameters in Sector 2 of Watari Irrigation Project, Kano , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Hillary T. OGBODO, Bilkisu L. MUHAMMAD-BELLO, Joshua ABAH, Saleh E.-Y. ABDULLAHI, Quantum Computing Applications in Software Engineering: A Scoping Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Usman GARBA, Abdullahi ADAMU, Mamuda MUHAMMAD, Physicochemical Characterisation of Mineral Sands from Northwestern Nigeria for Industrial Applications , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Sirajo ALHASSAN, Abdullahi A. ADAMU, Mohammed T. JIMOH, Experimental Characterization and Seasonal Energy Potential Assessment of Municipal Solid Waste in Kano City, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Enoch ADETONA, Oladiran K. ABUBAKRE, Rasheed A. MURIANA, Muhammad N. BALA, Abel A. ADEYI, Evaluation of Animal Dungs as Alternative Heat-Treating Materials in Foundry Shop , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Stephen G. UDEAGBARA, Judith A. KAINE, Ayodele DANIEL, Ifeanyi A. OGUAMAH, Performance Evaluation of an Additive in Formic Acid Blend for Well Stimulation , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
