Hydrogen Production from Flare Gas via Steam Methane Reforming: A Simulation-Based Approach
- Authors
-
-
Gbenga G. OSEKE
Author
-
Chisom S. AMADI
Author
-
Abubakar U. RAJI
Author
-
- Keywords:
- Hydrogen production; Flare gas; Steam methane reforming; DWSIM simulation; Gas flaring.
- Abstract
-
Hydrogen gas is receiving significant attention as a versatile and alternative energy carrier with the possibility of being used for different purposes in industries, including power or energy generation, chemical production, transportation, and iron and steel production, with minimal environmental impacts and concerns when produced from renewable and alternative sources. This study investigated hydrogen production from flare gas via Steam Methane Reforming (SMR) using a simulation-based approach. With Nigeria experiencing significant gas flaring challenges, the research explores converting flare gas into a valuable energy resource. Using DWSIM as the simulation tool, the SMR process was modelled under varying conditions of temperature, pressure, and steam-to-carbon (S/C) ratio. Results showed that Nigerian flare gas can achieve hydrogen yields of up to 72.9 mol% and methane conversion efficiencies exceeding 92% under optimal conditions (950°C, 5 bar, S/C = 4.0). The baseline case (850°C, 15 bar, S/C = 3.0) achieved a hydrogen yield of 68.7 mol% with 85.4% methane conversion, validating flare gas as a suitable feedstock for hydrogen production. Sensitivity analysis revealed that higher temperatures and lower pressures favoured hydrogen yield, while the optimal S/C ratio was between 2.5 and 3.5. Environmental impact analysis indicated a potential 27% reduction in CO₂ emissions compared to direct flaring, alongside elimination of unburned hydrocarbons and particulates. These findings demonstrate that flare-to-hydrogen conversion is technically feasible and environmentally beneficial, offering Nigeria a dual pathway to reduce flaring while advancing its clean energy transition.
- References
- Downloads
- Published
- 14-08-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Gbenga G. OSEKE, Chisom S. AMADI, Abubakar U. RAJI (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Cyril OCHERI, Victor S. AIGBODION, Esther O. AMEH, Ihebuchuwu C. EZEAKU, Chibuikem A. OKAFOR, Uchenna C. AMAZUE, Eddy R. OMONIGHO, Electrochemical Analysis of Azadirachta indica Leaves as a Corrosion inhibitor on Mild Steel in 1 M H2SO4 , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Murtala NAMAKKA, Abdulhamid S. ILIYASU, Utilisation of Supercritical Critical Fluids in Adsorption Process: A Comprehensive Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Israel A. OLUWAFEMI, Akaninyene B. OBOT, Emmanuel UBOM, Ayodele A. OLATUNJI, Mbuotidem G. ROBINSON, Design and Analysis of a Dual-Band Circular Microstrip Antenna Using Spatially Distributed CSRRs , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Olawale J. OLALUYI, Johnson O. ADEOGO, Adeniyi O. AJIBOYE, Mayowa O. ORESELU, Olarewaju T. OGINNI, Application of Machine Learning for Enhancing Fake Logo Detection , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Mela I. L. LASHIRU, Ganiyu A. BAKARE, Sabo M. HASSAN, Kamilu O. LAWAL, Data-Driven Observability Enhancement in Active Distribution Networks via Optimal Co-Deployment of DGs and D-PMUs Using Hybrid APSO-ASDA , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Nuhu MOHAMMED, Garkuwa Y. ADAMU, Abubakar A. FACHWAY, Aminu MOHAMMED, Afolayan A. OLASUNKANMI, Odoh F. CHIMEZIE, Muhammad A. YUSUF, Development of A Water-Recycling Pico Hydropower System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Auwalu M. ABDULLAHI, Musa M. BELLO, Ado HARUNA, Amina I. KHALEEL, Lubabatu B. ILA, Abdurrahaman M. BELLO, Adaptive Hybrid Compliant Control of a Desktop Upper-Limb Rehabilitation Robot , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Sirajo ALHASSAN, Abdullahi A. ADAMU, Mohammed T. JIMOH, Experimental Characterization and Seasonal Energy Potential Assessment of Municipal Solid Waste in Kano City, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Hafsah A. ABDULRAHMAN, Muhammad M. HAMIDU, Techno-Economic Optimization of a Hybrid PV-Wind-Waste-to Energy System for the University of Maiduguri , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammad M. HAMIDU, Mathew KATAMBI, Omar FARUQ, Techno-Economic and Environmental Assessment of a Solar PV-Based Microgrid for Residential Electrification in Gwange I, Maiduguri Using HOMER Pro , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Gbenga G. OSEKE, Fatima A. SHEHU, Muhammad K. ABBA, Effects of Completion Fluid Components on Reservoir Rock Matrix and Its Performance for Workover Applications , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
