Hydrogen Production from Flare Gas via Steam Methane Reforming: A Simulation-Based Approach
- Authors
-
-
Gbenga G. OSEKE
Author
-
Chisom S. AMADI
Author
-
Abubakar U. RAJI
Author
-
- Keywords:
- Hydrogen production; Flare gas; Steam methane reforming; DWSIM simulation; Gas flaring.
- Abstract
-
Hydrogen gas is receiving significant attention as a versatile and alternative energy carrier with the possibility of being used for different purposes in industries, including power or energy generation, chemical production, transportation, and iron and steel production, with minimal environmental impacts and concerns when produced from renewable and alternative sources. This study investigated hydrogen production from flare gas via Steam Methane Reforming (SMR) using a simulation-based approach. With Nigeria experiencing significant gas flaring challenges, the research explores converting flare gas into a valuable energy resource. Using DWSIM as the simulation tool, the SMR process was modelled under varying conditions of temperature, pressure, and steam-to-carbon (S/C) ratio. Results showed that Nigerian flare gas can achieve hydrogen yields of up to 72.9 mol% and methane conversion efficiencies exceeding 92% under optimal conditions (950°C, 5 bar, S/C = 4.0). The baseline case (850°C, 15 bar, S/C = 3.0) achieved a hydrogen yield of 68.7 mol% with 85.4% methane conversion, validating flare gas as a suitable feedstock for hydrogen production. Sensitivity analysis revealed that higher temperatures and lower pressures favoured hydrogen yield, while the optimal S/C ratio was between 2.5 and 3.5. Environmental impact analysis indicated a potential 27% reduction in CO₂ emissions compared to direct flaring, alongside elimination of unburned hydrocarbons and particulates. These findings demonstrate that flare-to-hydrogen conversion is technically feasible and environmentally beneficial, offering Nigeria a dual pathway to reduce flaring while advancing its clean energy transition.
- References
- Downloads
- Published
- 14-08-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Gbenga G. OSEKE, Chisom S. AMADI, Abubakar U. RAJI (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Osemwegie IKPONMWOSA-EWEKA, Alexander I. IDEMUDIA, Predicting Convective Heat Transfer Coefficient in TIG Welding via Adaptive Neuro-Fuzzy Inference System (ANFIS) , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Dauda ALI, Auwal SHUAIBU, Design and Performance Evaluation of Plastic–Sand Interlocking Blocks Using Waste Polyethylene Terephthalate (PET) and Low-Density Polyethylene (LDPE) for Sustainable Construction , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Yetunde M. ALADEITAN, Abdulmojeed O. OLUOGUN, Potential of Zinc Oxide Nanoparticles for Remediation of Oil-Contaminated Soil and Water , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Sheidu S. ONIMISI, Usman B. ABDULLAHI, Hayatudden S. BARAYAIS, Abubakar M. MUHAMMAD, Abubakar G. ISAH, Abubakar S. MOHAMMED, Mohammed U. GARBA, Safety Evaluation of Orifice Plate in Natural Gas Pipeline using Computer Aided Engineering (CAE): A Step Towards Food Security , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Olusegun A. AFOLABI, Olanrewaju A. OLANITE, Nsikan L. AKPAN, Design and Simulation of a Synchronous Reference Frame-Based Active Power filter for Harmonic Mitigation , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Ahmad IDRIS, Evaluation of Challawa Tannery Wastewater as Mixing and Curing Water for Concrete Production , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Mordecai C. EZEALOR, Bosede A. ORHEVBA, Ruth O. OYEBAMIJI, Quality Evaluation of Yogurt Produced from Chili Pepper-Derived Starter Culture , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Abdulkareem BELLO, Yusuf O. ADEIZA, Saleh S. LUKMAN, Muhammad A. ADAMU, Chibuzor A. OKAFOR, Abdulaziz A. ABDULSALAM, Production of Silica from ABU Zaria Dam Sand as an Eco-Friendly Corrosion Inhibitor Using Nanotechnology , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Muhammad N. IBRAHIM, Abubakar S. MOHAMMED, Iyanda M. ANIMASHAUN, Shehu ABDULKADIR, Sensor-Based Real-Time Soil Macronutrient Monitoring and Variable-Rate Fertilizer Application Machinery , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Abubakar A. IBRAHIM, Fatimah Y. GARBA, Fatimah A. MUHAMMAD, Ismail B. ADEFESO, Bello A. ISAH, Jacob OLAYIWOLA, Industrial and Biomedical Applications Biobased Polymers of Polylactic Acid and Polyhydroxybutyrate: A Review , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Gbenga G. OSEKE, Fatima A. SHEHU, Muhammad K. ABBA, Effects of Completion Fluid Components on Reservoir Rock Matrix and Its Performance for Workover Applications , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
