BAT-Optimized PID and ANFIS Torque-Based MPPT for a 0.5 MW PMSG-Based Wind Energy Conversion System Under Dynamic Wind Conditions
- Authors
-
-
Emmanuel T. ODEYEMI
Author
-
Ya’u S. HARUNA
Author
-
Ganiyu A. BAKARE
Author
-
Hassan B. MAMMAN
Author
-
Sabo M. HASSAN
Author
-
- Keywords:
- Permanent Magnet Synchronous Generator, Maximum Power Point Tracking, Adaptive Neuro-Fuzzy Inference System, Wind Energy Conversion System, and Wind Speed.
- Abstract
-
Efficient maximum power point tracking (MPPT) in variable-speed wind energy conversion systems (WECS) is challenged by nonlinear turbine–generator dynamics and rapidly varying wind conditions, which limit the effectiveness of conventional controllers. This paper proposes an intelligent torque-based MPPT framework for a 0.5 MW grid-connected permanent magnet synchronous generator (PMSG) WECS, combining metaheuristic optimization with adaptive neuro-fuzzy control. A high-fidelity MATLAB/Simulink model integrating turbine aerodynamics, generator dynamics, and power electronic conversion is developed for systematic evaluation. Three controllers; conventional PID, BAT-optimized PID (BAT-PID), and BAT-optimized adaptive neuro-fuzzy inference system (BAT-ANFIS), are comparatively assessed under step, ramp, and turbulent wind profiles. Results show that BAT optimization improves PID transient performance by 25–30% and reduces steady-state error to 5.2%. The proposed BAT-ANFIS further achieves a 40–45% reduction in settling time relative to conventional PID and a 15–20% improvement over BAT-PID, while maintaining DC-link voltage within ±1% of nominal (950–970 V). Torque ripple is reduced by ~30%, and MPPT efficiency reaches 100% under ramp conditions and ≈98% under turbulent profiles, outperforming BAT-PID (≈86–96%) and conventional PID (≈78–88%). These results demonstrate that integrating BAT-based optimization with neuro-fuzzy adaptation significantly enhances dynamic response, robustness, and real-time power extraction, establishing BAT-ANFIS as a high-performance MPPT solution for large-scale wind energy systems.
- References
- Downloads
- Published
- 23-05-2026
- Section
- Articles
- License
-
Copyright (c) 2026 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Auwalu M. ABDULLAHI, Musa M. BELLO, Ado HARUNA, Amina I. KHALEEL, Lubabatu B. ILA, Abdurrahaman M. BELLO, Adaptive Hybrid Compliant Control of a Desktop Upper-Limb Rehabilitation Robot , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Johnson O. ADEOGO, Olawale J. OLALUYI, Olumuyiwa A. OJO, Abayomi T. AYODELE, Elijah A. OLAJUYIN, Fasasi BELLO, Paul C. OFODU, Performance Evaluation of 3.5 kVA Hybrid Inverter Following Standard Engineering Practices and Safety Procedures , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Koliya LAAYE, Solomon O. OGUCHE, Ibrahim I. JIDDA, Abdullahi A. ADAMU, Economic Viability of Waste-to-Energy: Pathways for Sustainable Power Generation in Jalingo, Taraba State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammad M. HAMIDU, Mathew KATAMBI, Omar FARUQ, Techno-Economic and Environmental Assessment of a Solar PV-Based Microgrid for Residential Electrification in Gwange I, Maiduguri Using HOMER Pro , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Jafaru A. MOHAMMED, Thomas N. GUMA, Malachy SUMAILA, Mahdi MAKWAYO, A Review of Local Manufacturing of Borehole Windmill Gear Trains Using Reverse Engineering and Integrated Braking Systems , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Mela I. L. LASHIRU, Ganiyu A. BAKARE, Sabo M. HASSAN, Kamilu O. LAWAL, Data-Driven Observability Enhancement in Active Distribution Networks via Optimal Co-Deployment of DGs and D-PMUs Using Hybrid APSO-ASDA , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Suleiman ZUBAIR, Hassan ABDULAZEEZ, Bala A. SALIHU, Abubakar A. SHUAIBU, Design and Implementation of a BLE 5.0-Enabled Wearable Finger Mouse Using the XIAO nRF52840 Platform , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Abdulkareem BELLO, Saleh S. LUKMAN, Tasie M. CHIZE, Yusuf O. ADEIZA, Chibuzor A. OKAFOR, Abdullahi O. YAKUBU, Design, Simulation, and 3D Printing of a Lightweight Drone Frame for Farm Monitoring , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Isaac O. OLAOYE, Design Modification and Performance Evaluation of an Existing Cashew Nut Shell Liquid (CNSL) Extraction Machine , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Ismaila MAHMUD, Mahmud MUSTAPHA, Sulaiman H. SULAIMAN, Ibrahim ABDULWAHAB, Ibrahim A. SHEHU, Aminu J. ALIYU, Yusuf S. ABU, Nuraddeen A. ILIYASU, Solar Irradiance Forecast using Feed Forward Neural Network: A Case Study of Zaria Town , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Emmanuel T. ODEYEMI, Ya’u S. HARUNA, Ganiyu A. BAKARE, Hassan B. MAMMAN, Sabo M. HASSAN, Software-in-the-Loop Validation of an Adaptive Particle Swarm Optimization-Based MPPT Controller for Real-Time Photovoltaic System , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Mela I. L. LASHIRU, Ganiyu A. BAKARE, Sabo M. HASSAN, Kamilu O. LAWAL, Data-Driven Observability Enhancement in Active Distribution Networks via Optimal Co-Deployment of DGs and D-PMUs Using Hybrid APSO-ASDA , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Umar A. ADAMU, Ya’u S. HARUNA, Ganiyu A. BAKARE, Buhari H. MAMMAN, Kunduli MUSTAPHA, Hadi M. ADAMU, Ismaila MAHMUD, Design and Simulation of a 200 MWp Floating Solar PV Plant Integrated with the Kainji Hydropower Plant, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
