Hydrogen Production from Flare Gas via Steam Methane Reforming: A Simulation-Based Approach
- Authors
-
-
Gbenga G. OSEKE
Author
-
Chisom S. AMADI
Author
-
Abubakar U. RAJI
Author
-
- Keywords:
- Hydrogen production; Flare gas; Steam methane reforming; DWSIM simulation; Gas flaring.
- Abstract
-
Hydrogen gas is receiving significant attention as a versatile and alternative energy carrier with the possibility of being used for different purposes in industries, including power or energy generation, chemical production, transportation, and iron and steel production, with minimal environmental impacts and concerns when produced from renewable and alternative sources. This study investigated hydrogen production from flare gas via Steam Methane Reforming (SMR) using a simulation-based approach. With Nigeria experiencing significant gas flaring challenges, the research explores converting flare gas into a valuable energy resource. Using DWSIM as the simulation tool, the SMR process was modelled under varying conditions of temperature, pressure, and steam-to-carbon (S/C) ratio. Results showed that Nigerian flare gas can achieve hydrogen yields of up to 72.9 mol% and methane conversion efficiencies exceeding 92% under optimal conditions (950°C, 5 bar, S/C = 4.0). The baseline case (850°C, 15 bar, S/C = 3.0) achieved a hydrogen yield of 68.7 mol% with 85.4% methane conversion, validating flare gas as a suitable feedstock for hydrogen production. Sensitivity analysis revealed that higher temperatures and lower pressures favoured hydrogen yield, while the optimal S/C ratio was between 2.5 and 3.5. Environmental impact analysis indicated a potential 27% reduction in CO₂ emissions compared to direct flaring, alongside elimination of unburned hydrocarbons and particulates. These findings demonstrate that flare-to-hydrogen conversion is technically feasible and environmentally beneficial, offering Nigeria a dual pathway to reduce flaring while advancing its clean energy transition.
- References
- Downloads
- Published
- 14-08-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Gbenga G. OSEKE, Chisom S. AMADI, Abubakar U. RAJI (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Victoria A. UMEJURU, Isaac E. IHUA-MADUENYI, Adaobi S. NWOSI-ANELE, Performance Evaluation and Economic Assessment of Electrical Submersible Pumps for Heavy Oil Production in Mature Niger Delta Oilfields , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Yetunde M. ALADEITAN, Damilola V. ABRAHAM, Abdulmojeed O. OLUOGUN, Abdulwasiu ABDURRAHMAN, A Critical Review of Surrogate Reservoir Modelling for Uncertainty Quantification in Thin Oil Rim Reservoirs , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Sulaiman Y. ADAMU, Fadimatu N. DABAI, Abdulazeez Y. ATTA, Baba Y. JIBRIL, Preparation and Characterization of Enhanced Hierarchical Zn-Ni/HZSM-5 Catalysts for Potential use in Catalytic reactions to Upgrade Bio-Oil and Hydrogen from Biomass Pyrolysis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Yetunde M. ALADEITAN, Damilola V. ABRAHAM, A Data-Driven Surrogate Framework for Economic Optimization of Thin Oil Rim Developments: A Comprehensive Methodological Review and Niger Delta Application , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Ayodele DANIEL, Mercy O. AKEJU, Sunday O. ISEHUNWA, Abel A. ADEYI, Adebayo T. OGUNYEMI, Decline Curve Analysis of Continuous Injection Gas Lifted Wells , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Ndagi MAMUDU, Ibrahim S. MOHAMMED, Mohammed ALIYU, Peter DANIEL, Timothy Y. AKANDE, Bala A. GARBA, Development and Performance Evaluation of Biomass Pyrolysis System for Biofuel Production , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Luqman K. SALATI, Sani D. MUHAMMAD, Jacob T. ADEYEMO, Simulation of Trucks Haulage Operation at Ashaka Cement Company in Gombe State, North-Eastern Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Olusiji A. ADEYANJU, Joseph O. OLAIDE, Machine Learning Models for Predicting Flow Rate for Niger Delta Oil Wells , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Ojochide P. DAMIAN, Fadimatu N. DABAI, Abdulwasiu ABDURRAHMAN, Kamiludeen OLANREWAJU, Bilyamin ABDULMUMIN, Grace A. OLUGBENGA, A Simulation-Driven Strategy for Improved Expandable Polystyrene Synthesis via Multi-Stage Initiator Dosing , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Koliya LAAYE, Solomon O. OGUCHE, Ibrahim I. JIDDA, Abdullahi A. ADAMU, Economic Viability of Waste-to-Energy: Pathways for Sustainable Power Generation in Jalingo, Taraba State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Gbenga G. OSEKE, Fatima A. SHEHU, Muhammad K. ABBA, Effects of Completion Fluid Components on Reservoir Rock Matrix and Its Performance for Workover Applications , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
