Design and Implementation of IOT-Based Intravenous (IV) Bag Monitoring and Alert System
- Authors
-
-
Gregory T. AKAU
Department of Electrical/Electronics, Nigerian Defence Academy, Kaduna, Nigeria
Author
-
Abel AIROBOMAN
Department of Electrical/Electronics, Nigerian Defence Academy, Kaduna, Nigeria
Author
-
Nathaniel DALLA
Department of Electrical/Electronics, Nigerian Defence Academy, Kaduna, Nigeria
Author
-
- Keywords:
- Intravenous (IV) monitoring, IoT-based healthcare, Arduino Uno, drip rate monitoring, ESP8266 Wi-Fi, ThingSpeak cloud, hospital automation.
- Abstract
-
Health, being a critical aspect of daily life, demands heightened attention, especially when a patient is hospitalized. In densely populated hospitals with limited nursing staff, the continuous monitoring of Intravenous (IV) fluid becomes a challenge. If the IV fluid is not properly monitored, severe consequences may arise, such as blood reflux or the entry of air bubbles into the patient's bloodstream when the fluid bottle runs dry. To address this, the project proposes the design and implementation of an IoT-based intravenous infusion monitoring and Alert System using the Huamao Communication 12 radio frequency module (HC-12) for wireless communication. The system also integrates Espressif Wi-Fi SoC ESP8266 wi-fi connectivity for real-time data transmission to the ThinkSpeak cloud platform. The hardware setup includes a load cell with an HX711 interface for continuous measurement of the IV fluid's weight, and a laser sensor positioned on the drip chamber to monitor the droplet rate. An Arduino Uno microcontroller coordinates the sensors and decision logic. When the fluid level drops below a critical threshold or the drip rate becomes abnormal, an alert is transmitted wirelessly via the RF module to a remote receiver unit (e.g., nurse’s station), where the patient's information and alert status are displayed. Additionally, the ESP8266 module uploads real-time data to the internet for remote monitoring and analytics. The performance evaluation of the prototype demonstrated a system success rate of approximately 96.8% in accurately detecting both low-fluid and abnormal drip rates. This low-cost, easily deployable system enhances patient safety by ensuring timely intervention from medical staff and is particularly suited for resource-constrained hospitals that cannot afford expensive commercial IV monitoring system.
- References
- Downloads
- Published
- 15-11-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Obafemi A. IBITOYE, Jemimah O. TOLU-ALALADE, Solar-Powered Low-Cost Housing: Designing Off-Grid Communities with Interlocking Stabilised Soil Blocks (ISSB) , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Abdulrahman S. USMAN, Folorunsho ABERUAGBA, Moses A. OLUTOYE, Umar MUSA, Mohammed ALHASSAN, Calcium Oxide Derived from Okpella Limestone as a Heterogeneous Catalyst for Biodiesel Production: Synthesis, Characterisation and Stability Assessment , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Aliu S. SALIU, Ejike C. ANENE, Buhari M. HASSAN, Sabo M. HASSAN, Salisu H. MOHAMMED, Nafisa S. USMAN, Addressing Resource Allocation Challenges in Wireless Networks with Cultural Smell Agent Optimization Algorithms: A Literature Survey , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Victor A. NSABA, Sabiu B. YUSUF, Kafayat A. IBRAHIM, Consumer Perceptions of Artificial Intelligence (AI)-Driven Smart Grids and Energy Efficiency in Northwest Nigeria’s Power Distribution Sector: A Multi-State Case Study of Sokoto, Kebbi, and Zamfara , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Benjamin T. ABUR, Abubakar A. WARA, David ISAH, Mary D. IGBUR, Catherine N. KWAGHMANDE, Co-Gasification of Sugarcane Bagasse and Coal: A Study on Thermal Characteristics and Efficiency , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammad M. HAMIDU, Abubakar M. EL-JUMMAH, Muhammad SHUWA, An Assessment of Power Sources for Improved Energy Supply in University of Maiduguri , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Opeyemi A. ASAJU, Cephas ADELORE, Akintunde O. ONAMADE, Jonathan B. ADEWUMI, Glory A. ODUBANJO, Gbenga O. WILLIAMS, Enoch O. OYELEYE, Assessing Thermal Comfort and its Impact on Student Satisfaction in Selected Hostels at Caleb University, Imota, Lagos State , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Oluwaseun S. OGUNGBEMI, Geophysical Approach to Groundwater Resource Appraisal in Afe Babalola University, Ado-Ekiti, Southwestern Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Martins Y. OTACHE, Iyanda M. ANIMASHAUN, Sadeeq A. MOHAMMED, Emmanuel O. AGBESE, Spatiotemporal Variability and Trend Analysis of Rainfall and Temperature in Northern Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 1 (2025): July 2025
- Oyeyemi T. AFOROLAGBA-BALOGUN, Olumide A. TOWOJU, Characterization of Fuel Produced from Nylon (Polyamide) and Polyethylene Terephthalate (PET) Wastes with Pyrolysis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
