Economic Viability of Waste-to-Energy: Pathways for Sustainable Power Generation in Jalingo, Taraba State, Nigeria
- Authors
-
-
Koliya LAAYE
Department of Mechanical Engineering, Faculty of Engineering, Bayero University, Kano, Nigeria
Author
-
Solomon O. OGUCHE
Department of Biochemistry, Faculty of Basic Medical Sciences, Bayero University, Kano, Nigeria
Author
-
Ibrahim I. JIDDA
Department of Mechanical Engineering, Faculty of Engineering, Bayero University, Kano, Nigeria
Author
-
Abdullahi A. ADAMU
Department of Mechanical Engineering, Faculty of Engineering, Bayero University, Kano, Nigeria
Author
-
- Keywords:
- Incineration, landfill gas, LCOE, techno-economic, waste-to-energy.
- Abstract
-
This study evaluates the technical and economic viability of waste-to-energy (WtE) technologies for sustainable electricity generation in Jalingo metropolis, Taraba State, Nigeria. Two WtE pathways were assessed: (i) thermal conversion through incineration with power generation, and (ii) landfill gas (LFG) capture with reciprocating engines. Locally reported municipal solid waste (MSW) data and performance-cost ranges from literature were applied to estimate electricity potential, installed capacity, levelized cost of electricity (LCOE), net present value (NPV), and internal rate of return (IRR). The waste composition was dominated by plastics (29.67–34.67%) and agricultural residues (28–29%), followed by paper/cardboard (9.88–11.93%), textiles (4.04–9.20%), and food waste (5.66–6%). Metals (0.42–1.11%) and glass (0.90–1.30%) constituted the smallest fractions. Moisture content ranged from 25.40% at Mile Six dumpsite to 28.98% at Pantinapu; volatile matter peaked at 38.84% at Mile Six. Heat values between 6.32 and 6.68 MJ/kg confirmed the technical feasibility of incineration-based energy recovery. Electricity generation potential was estimated at 39,417.74 kWh/day from incineration and 1,644,106.24 MWh/year (≈4.5 million kWh/day) from LFG, capable of supplying approximately 17,127 and 1,957 households respectively, based on average household consumption of 840 kWh/year. Economic analysis revealed positive NPVs ($1.20–1.45 million) and IRRs of 18–79% at a tariff of N250/kWh (US $0.15), demonstrating profitability. Environmental assessment indicated that methane combustion for electricity reduced carbon dioxide emissions by about 88.18% compared to uncontrolled waste disposal. The findings highlight that municipal solid waste in Jalingo possesses sufficient energy content to support WtE initiatives. Both incineration and LFG capture not only offer substantial electricity generation potential but also present economically viable and environmentally sustainable alternatives to current waste management practices.
- References
- Downloads
- Published
- 06-10-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Muhammad M. HAMIDU, Abubakar M. EL-JUMMAH, Muhammad SHUWA, An Assessment of Power Sources for Improved Energy Supply in University of Maiduguri , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Ibrahim M. GANA, Abdullahi YUSUF, Agidi GBABO, Micheal EPHRAIM, Abubakar M. HASSAN, Development and Testing of an Automated Solar-Powered Nutrient Film Technique (NFT) Hydroponic Planting System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Abdulkarim AMINU, Mohammed ALIYU, Ibrahim S. MOHAMMED, Iyanda M. ANIMASHAUN, Peter DANIEL, Mohammad USMAN, Production and Optimisation of Parameters for Density and Ash Content of Briquettes Produced from Sorghum Stalks and Groundnut Shells Using African Locust Bean (Parkia biglobosa) Pulp as a Binding Agent , FUDMA Journal of Engineering and Technology: Vol. 1 No. 1 (2025): July 2025
- Nuhu MOHAMMED, Garkuwa Y. ADAMU, Abubakar A. FACHWAY, Aminu MOHAMMED, Afolayan A. OLASUNKANMI, Odoh F. CHIMEZIE, Muhammad A. YUSUF, Development of A Water-Recycling Pico Hydropower System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammad M. HAMIDU, Development of MATLAB-Based Model for Solar Radiation Prediction and Photovoltaic Panel Tilt Optimization Angle for Maiduguri Region, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Abdulrahman S. USMAN, Folorunsho ABERUAGBA, Moses A. OLUTOYE, Umar MUSA, Mohammed ALHASSAN, Calcium Oxide Derived from Okpella Limestone as a Heterogeneous Catalyst for Biodiesel Production: Synthesis, Characterisation and Stability Assessment , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Habib I. ABDULAZEEZ, Bala ABDULLAHI, Abdullahi AHMED, Ibrahim A. TUKUR, Experimental Investigation of Solar Photovoltaic Tilt Angles for Maximum Energy Harvest in Kogi State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Sheidu S. ONIMISI, Usman B. ABDULLAHI, Hayatudden S. BARAYAIS, Abubakar M. MUHAMMAD, Abubakar G. ISAH, Abubakar S. MOHAMMED, Mohammed U. GARBA, Safety Evaluation of Orifice Plate in Natural Gas Pipeline using Computer Aided Engineering (CAE): A Step Towards Food Security , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Ismaila MAHMUD, Mahmud MUSTAPHA, Sulaiman H. SULAIMAN, Ibrahim ABDULWAHAB, Ibrahim A. SHEHU, Aminu J. ALIYU, Yusuf S. ABU, Nuraddeen A. ILIYASU, Solar Irradiance Forecast using Feed Forward Neural Network: A Case Study of Zaria Town , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Damilare L. ADEKEYE, Uche M. IROKA, A Microcontroller-Based Intelligent Electricity Theft Detection and Prevention System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
