Co-Gasification of Sugarcane Bagasse and Coal: A Study on Thermal Characteristics and Efficiency
- Authors
-
-
Benjamin T. ABUR
Department of Mechanical/Production Engineering, Abubakar Tafawa Balewa University, Bauchi, Nigeria
Author
-
Abubakar A. WARA
National Board for Technology Incubation (NBTI), Abuja, Nigeria
Author
-
David ISAH
Grand Cereals Limited, Subsidiary of UACN PLC, Bukuru, Jos, Nigeria
Author
-
Mary D. IGBUR
Technical and Vocational Skills Training development (TVSTD), Industrial Training Fund Headquarters, Jos, Nigeria
Author
-
Catherine N. KWAGHMANDE
Benue State University, Makurdi, Benue State, Nigeria
Author
-
- Keywords:
- Co-gasification, sugarcane bagasse, coal, thermal characteristics.
- Abstract
-
Biomass fuels offers sustainable alternative to traditional energy sources, mitigating pollution and landfill disposal challenges. This work aim at identifying an optimal blend for enhancing gasification efficiency, operational stability and reduced emissions. Ultimate analysis was adopted for elemental composition determination, proximate analysis for physical and chemical properties while the energy content was determined through calorimetry and thermal degradation behavior using the thermo-gravimetric analysis. Elemental analysis of coal, sugar cane bagasse and their blends revealed principal chemical constituents of carbon, hydrogen and oxygen, with coal demonstrating higher carbon content. Nitrogen composition is negligible for pure and blended samples. Results indicate that coal provide more energy than bagasse owing to its lower ash content and higher carbon concentration. Conversely, calorific value of blends increased with proportion of bagasse, likely due to its high reactivity, which catalyzes coal combustion. Thermo-gravimetric analysis (TGA) displays maximum de-volatilization at 900°C, with rapid weight loss between 300-550 °C for all blends. Derivative (DTG) profiles of blends exhibit two peaks: first peak at 320-350°C, with second peak at 400-800°C representing sub-bituminous coal de-volatilization. This study concludes that blending 10% coal with 90% sugarcane bagasse optimize calorific values, thermal stability, efficiency and minimizes environmental pollution.
- References
- Downloads
- Published
- 08-08-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Mathew O. ADEOTI, Victor N. HARUNA, Omolayo M. IKUMAPAYI, Timothy A. ADEKANYE, Development and Characterization of Epoxy-Based Asbestos-Free Brake Pad Composites Reinforced with Cow Hoof Particulates , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Abdultoyyib A. ALABI, Adamu S. ABUBAKAR, Patrick U. OKORIE, Abdulwahab IBRAHIM, Development of a Non-Convex Economic Load Dispatch Across Small to Very Large-Scale Power Systems Using Improved Sine Cosine Algorithm , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Ayodeji T. BALOGUN, Onoghwarite E. OHIMOR, Adegboyega L. ALUKO, Modelling and Performance Optimization of a Dual Fuel Mode Power Generation System (A Case Study of Allanblackia floribunda Seed Oil) , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Muhammad M. HAMIDU, Mathew KATAMBI, Omar FARUQ, Techno-Economic and Environmental Assessment of a Solar PV-Based Microgrid for Residential Electrification in Gwange I, Maiduguri Using HOMER Pro , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Joseph O. AJAYI, Adekunle T. ADENIYI, Mufliah G. OMOFOYEWA, Abel A. ADEYI, Abdulwahab GIWA, Evaluation on the Rheological Properties of Water-Based Drilling Mud: A Case Study of Ire-Ekiti Clay , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Temitope E. OLUBODUN, Joshua T. AKINWAMIDE, Olugbenga O. AMU, Characterization of Shear Strength Parameters for Construction Works in Ado-Ekiti Metropolis, Ekiti State, Southwestern Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Paul A. OMALE, Hammed O. SALAUDEEN, Sunday S. IGILA, Enoch T. CHIN, Determination of the Physicochemical Composition of Processed Powdered Pepper (Capsicum spp.) Sold in Selected Markets in Makurdi, Benue State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Vincent B. ONIGBARA, Sunday I. AGU, Muftau A. GBENLE, Metal-Based Biomaterials for Clinical Implant Applications: Materials and Performance – A Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Oluwaseun S. OGUNGBEMI, Aquifer Characterisation and Vulnerability Assessment in a Typical Basement Complex Terrain , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Samuel E. CHUKWU, Martins Y. OTACHE, Precious O. ATEMOAGBO, Emmanuel O. AGBESE, Copula-Based Modelling of Drought Severity-Duration-Frequency Relationship of Sokoto-Rima-River Basin, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
