Empirical Load Profiling and Categorisation for a Hybrid Renewable Microgrid Serving an Integrated Farm in Nigeria
- Authors
-
-
Vandi JUSU
Author
-
Eugene O. AGBACHI
Author
-
Jibril A. BALA
Author
-
- Keywords:
- Demand-side management, Empirical load profiling, Hybrid renewable energy, Load criticality, Microgrid.
- Abstract
-
Off-grid hybrid renewable microgrids often serve farms that combine livestock and horticulture, yet published sizing studies rarely distinguish loads that cannot be interrupted without harming animals or crops from those that can. This paper presents an empirical load-profiling and criticality-categorisation study of an integrated farm in Minna, Nigeria, comprising a 400-cow dairy unit, a 25,000-bird layer poultry unit, a 10,000-bird broiler poultry unit, and a 5,000 m² greenhouse. Forty appliances, totalling 320.93 kW of installed capacity, were inventoried and disaggregated into hourly dispatch profiles for the Rainy, Harmattan, and Dry seasons. Each appliance was then classified into three biological-criticality tiers, Tier 1 (never shed), Tier 2 (shed only once battery state of charge falls low), and Tier 3 (fully deferrable), following a review process that checked functional consistency against species-specific thermal risk. The tiered profiles were expanded into three parallel, verified annual series covering all 8,760 hours of the year. Statistical analysis showed that the farm-level annual load factor reaches 0.628, giving a peak-to-average ratio of 1.59. Tier 1 alone showed a lower load factor of 0.446 and a higher peak-to-average ratio of 2.24, and was strongly correlated with the dairy milking schedule. The Tier 1 load duration curve remained above 24 kW for 58.1% of the year and never fell below 13.65 kW, a sustained base-load pattern with direct implications for battery-energy and diesel or biogas backup sizing. The novelty of this study lies in combining appliance-level disaggregation, three-season synthesis, and a physiologically justified three-tier criticality classification for a combined livestock-and-horticulture microgrid. The dataset and classification are recommended as a reusable, empirically grounded input for future research on microgrid sizing, reliability assessment, and demand-side management.
- References
- Downloads
- Published
- 17-10-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Vandi JUSU, Eugene O. AGBACHI, Jibril A. BALA (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Danladi K. GARBA, Emmanuel O. AWEDA, Nuhu A. ADEMOH, Fredrick NGOLEMASANGO, Pascal A. UBI, Akor TERNGU, Lawal KABIR, Shuaibu O. YAKUBU, The Effects of Gum Arabic Matrix on the Hardness and Water Absorption of Agro-Based (Banana Pseudostem) Hybrid Composites , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Sulaiman Y. ADAMU, Fadimatu N. DABAI, Abdulazeez Y. ATTA, Baba Y. JIBRIL, Preparation and Characterization of Enhanced Hierarchical Zn-Ni/HZSM-5 Catalysts for Potential use in Catalytic reactions to Upgrade Bio-Oil and Hydrogen from Biomass Pyrolysis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Mu’azu ABUBAKAR, Abubakar B. ALIYU, Dauda GARBA, Fabrication, Characterization, and Application of Clay-Based Ceramic Membranes for Oily Wastewater Treatment: A Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Miracle A. OLAITAN, Musa SURAJUDEEN, Adeniyi G. ADEOGUN, Ecological and Public Health Implications of Dumpsite Leachate: Bio-Monitoring of Aquatic Organisms and Community Perceptions in Offa Garage Axis, Ilorin, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Salisu MOHAMMED, Abdulfatai JIMOH, Abdullahi M. EVUTI, Abdulwahab GIWA, Abubakar A. IBRAHIM, Pretreatment and Characterization of Selected Precursors for Chitin/Chitosan Production , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Abdulkareem BELLO, Yusuf O. ADEIZA, Saleh S. LUKMAN, Muhammad A. ADAMU, Chibuzor A. OKAFOR, Abdulaziz A. ABDULSALAM, Production of Silica from ABU Zaria Dam Sand as an Eco-Friendly Corrosion Inhibitor Using Nanotechnology , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Isaac O. UKRAKPO, Osemwegie IKPONMWOSA-EWEKA, Prediction of Weld Strain Using Artificial Neural Network: A Modeling Approach , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Mohammed B. ABDULLAHI, Impact of Agro-Chemicals on Groundwater Quality and Soils of Irrigation Sites: A Case Study of Chanchaga Irrigation Scheme, Minna, Niger State , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Toyin OKEBULE, Development of an Ocular Disease Prediction Using Deep Learning , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Nafisa A. ABDULHAMID, Danladi D. USMAN, Kabiru I. JAHUN, Rotkangmwa J. SATI, Yahaya U. JAURO, Abdulmajid M. HASHIR, Yusuf G. SHIMBURA, Development of a Solar Dryer with Multi-Products and a Residual Moisture Control System , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
