Modelling and Performance Optimization of a Dual Fuel Mode Power Generation System (A Case Study of Allanblackia floribunda Seed Oil)
- Authors
-
-
Ayodeji T. BALOGUN
Author
-
Onoghwarite E. OHIOMOR
Author
-
Adegboyega L. ALUKO
Author
-
- Keywords:
- Modelling; Optimization; Performance, Allanblackia floribunda Seed Oil.
- Abstract
-
This study focuses on the optimization of a small-scale, spark-ignition power generation system operating on a dual fuel arrangement of petrol and Liquefied Petroleum Gas (LPG) The research addresses the challenge of calibrating such systems for optimal performance, which volves balancing often conflicting objectives like fuel efficiency, power output, and emissions A Response Surface Methodology (RSM) framework, employing a Central Composite Design (CCD) of experiments, was used to investigate the effects of five key operating parameters Engine Load, Generator Speed, Ignition Timing, Air-Fuel Ratio, and Compression Ratio Empirical quadratic models were developed and validated to predict key responses Brake Thermal Efficiency (BTE), Specific Fuel Consumption (SFC), Carbon Monoxide (CO), and Nitrogen Oxides (NOx) emissions, and Power Output The Desirability Function Approach was then applied for multi-response optimization to identify the bestcompromise operating conditions for both petrol and LPG modes. The results demonstrate that while both fuels can achieve nearly identical thermal efficiency at their respective optima, LPG operation enables a 22 9% higher power output. However, this is accompanied by a 5.56% increase in mass-based fuel consumption and significant increases in CO (66.2%) and NOx (14.1%) emissions under the high-load optimization strategy The study concludes that LPG is a superior fuel for applications demanding high power density, provided that the increased emissions are managed through targeted calibration or after-treatment, the Allanblankia florrbunda Seed Oil was used as case study, thereby offering a viable path for cleaner and more powerful decentralized electricity generation.
- References
- Downloads
- Published
- 25-09-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Ayodeji T. BALOGUN, Onoghwarite E. OHIOMOR, Adegboyega L. ALUKO (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- George AKWEC, Segun E. ADEBAYO, Caroline O. ALENOGHENA, Design and Construction of Forced-Air Heating systems for Poultry Brooding: A Comprehensive Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Muhammed A. ADAWUDI, Danlami MALIKI, Ibrahim M. ABDULLAHI, Electric Fish Optimizer-Based Hyperparameter Tuning of MLP for Fault Diagnosis in Grid-Connected Photovoltaic Systems , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Abdullahi YAHAYA, Ahmad ADO, Jaju A. MUHAMMAD, Zaharaddeen G. SANI, Baba A. OLUWA, Abdulazeez A. YUSUF, Kinetic Modelling of Sonocatalytic Phenol Degradation over Alumina-Supported Copper Oxide Catalyst , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Muazu D. ZAKARI, Md R. KAMAL, Wada I. MUHAMMAD, Nuraddeen M. NASIDI, Dahiru MOHAMMED, Agro-Hydrological Modelling Systems in Peninsula Malaysia: A Comprehensive Review and a Guide towards Model Development , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Yetunde M. ALADEITAN, Abdulmojeed O. OLUOGUN, Potential of Zinc Oxide Nanoparticles for Remediation of Oil-Contaminated Soil and Water , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Idris M. WADA, Abba IBRAHIM, Genesis ISHAYA, Performance Evaluation of Climate Products with Validation Using Bootstrapping and Climate Extremes in the Hadejia-Jama’are River Basin, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Isaac O. OLAOYE, Design Modification and Performance Evaluation of an Existing Cashew Nut Shell Liquid (CNSL) Extraction Machine , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Isiaq O. ALABI, Hassan T. ABDULAZEEZ, Sulaiman AHMAD, Yahaya M. SANI, Scalability Versus Accuracy Trade-offs in Distributed Big Data Processing Frameworks: A Comparative Evaluation of Apache Spark, Flink, and Dask Using Benchmark Datasets , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Aminu BALA, Nasiru B. KADANDANI, Isiyaku ABUBAKAR, Performance Evaluation of Fuzzy Logic and Fractional Order PI Controllers for Electric Vehicle Wireless Charging System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Ephraim G. KEFAS, Abdulfatai JIMOH, Mohammed A. EVUTI, Abubakar A. IBRAHIM, Abdulwahab GIWA, Adeola G. OLUGBENGA, Luffa Sponge, Banana Stem and Delonix regia Seed Characterization as Potential Biosorbents for Industrial Wastewater Remediation , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
