Decline Curve Analysis of Continuous Injection Gas Lifted Wells
- Authors
-
-
Ayodele DANIEL
Author
-
Mercy O. AKEJU
Author
-
Sunday O. ISEHUNWA
Author
-
Abel A. ADEYI
Author
-
Adebayo T. OGUNYEMI
Author
-
- Keywords:
- Decline curve analysis, Developed reserves, Production rate, Gas lift, Arps’ exponential model.
- Abstract
-
Decline Curve Analysis is one of the established techniques for reservoir performance evaluation and estimation of developed reserves. While it has been well utilized for natural drive production, there have been challenges in accurate evaluation of gas lifted wells because of additional energy that supplements the natural which changes future production rate of the reservoir and distorts the reservoir’s production decline trend. For continuous gas lifted wells, several attempts have been made to model production rates, but none have been found to be simple or accurate. In this article the principle of superposition has been applied such that the production rate of a well at a time, t after gas-lift has been introduced would be the sum of the flow rate due to the natural flow and gas-lift induced flow rate. Four actual well production data sets obtained from the SPE Data Repository and from reservoirs in literature from Niger Delta were used to assess the model. The analysis done included cases with and without gas lift and statistical analysis was done to evaluate the error margin. The equation derived is a mathematical model in which the traditional Arps’ exponential model accounts for the natural flow and a power law model accounts for the gas-lift induced flow expressed as:
q_t=q_inf 〖[e〗^(-Dt)+βt^(-λD)]
The model proposed showed that 0.48MMstb, 0.31MMstb, 8.75MMstb, and 1.23MMstb respectively would be produced when gas-lift is introduced as opposed to 0.26MMstb, 0.16MMstb, 7.96MMstb, and 1.10MMstb without gas-lift respectively, from well 1 to 4. The model also predicted future rates that were similar to the actual field data with correlation coefficient of 0.884, 0.806, 0.917, and 0.874 respectively. This statistical result indicates the effectiveness of the model in predicting the production decline rate of gas-lifted wells.
- References
- Downloads
- Published
- 29-08-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Ayodele DANIEL, Mercy O. AKEJU, Sunday O. ISEHUNWA, Abel A. ADEYI, Adebayo T. OGUNYEMI (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Daniel N. MBACHIRIN, David E. ABEL, Paul A. OMALE, Precision Agriculture Technologies for Smallholder Farming Systems in Developing Countries: A Scoping Review of Opportunities, Limitations and Future Directions , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Oluwaseun S. OGUNGBEMI, Aquifer Characterisation and Vulnerability Assessment in a Typical Basement Complex Terrain , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Isiaq O. ALABI, Hassan T. ABDULAZEEZ, Sulaiman AHMAD, Yahaya M. SANI, Scalability Versus Accuracy Trade-offs in Distributed Big Data Processing Frameworks: A Comparative Evaluation of Apache Spark, Flink, and Dask Using Benchmark Datasets , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Beabu B. DUMKHANA, Dandison M. WALI, Assessment of the Impact of Tractor Noise Exposure on Operators and Bystanders , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Yahaya U. JAURO, Danladi D. USMAN, Lawan G. ABUBAKAR, Yusuf G. SHIMBURA, Aminu MOHAMMED, Design and Fabrication of Tapered Screw Briquetting Machine , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Samaila J. EL-PATEH, Ibrahim IDRIS, Waste Management in Bauchi Metropolis: Solid Measure and Characterization in Municipality , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Nafisa A. ABDULHAMID, Danladi D. USMAN, Kabiru I. JAHUN, Rotkangmwa J. SATI, Yahaya U. JAURO, Abdulmajid M. HASHIR, Yusuf G. SHIMBURA, Development of a Solar Dryer with Multi-Products and a Residual Moisture Control System , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Israel A. OLUWAFEMI, Akaninyene B. OBOT, Emmanuel UBOM, Ayodele A. OLATUNJI, Mbuotidem G. ROBINSON, Design and Analysis of a Dual-Band Circular Microstrip Antenna Using Spatially Distributed CSRRs , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Chukwuemeka S. IBEH, Abubakre O. KAMARDEEN, Saka A. ABDULKAREEM, Aliyu A. ABDULLAHI, Experimental Study on the Characterisation and Thermo-Physical Properties of Graphene-Agro Based Hybrid Nanofluids , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Yusuf T. BAFFA, Muhammad Y. MUHAMMAD, Aliyu SHUAIBU, Enhanced Detection and Classification Models for Distributed Denial-of-Service Using Time-Based Features in Cybersecurity , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Enoch ADETONA, Oladiran K. ABUBAKRE, Rasheed A. MURIANA, Muhammad N. BALA, Abel A. ADEYI, Evaluation of Animal Dungs as Alternative Heat-Treating Materials in Foundry Shop , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
