Improvement of Power Efficiency of Sensor Network Using Ant Colony Optimization and K-Means Clustering Technique
- Authors
-
-
Nsikan L. AKPAN
Author
-
Akaniyene OBOT
Author
-
Olusegun A. AFOLABI
Author
-
- Keywords:
- Ant colony optimization, clustering, energy efficiency, K-means, multi-objective optimization, routing, wireless sensor networks.
- Abstract
-
Energy-constrained routing remains a central limitation in wireless sensor networks (WSNs), because repeated transmission, poor cluster-head selection, and unreliable paths accelerate battery depletion and fragment sensing coverage. This paper presents a K-means-guided adaptive multi-objective ant colony optimization (KMA-MOACO) framework that combines logical node clustering, residual-energy-based cluster-head rotation, multi-pheromone route construction, and Pareto-dominance-based selection. The routing problem is formulated to minimize communication energy and end-to-end delay while maximizing packet-delivery reliability, subject to node-energy, transmission-range, link-quality, and delay constraints. A first-order radio model is used in a 100 m × 100 m simulation field with 50–150 stationary nodes; the reported comparative case contains 100 nodes initialized with 2 J, periodic 64-byte packets, and 10–30 ants per routing round. KMA-MOACO is evaluated against a conventional ACO routing scheme and a generic multi-objective ACO implementation. In the reported representative case, KMA-MOACO reduced average energy consumption to 0.5676 J and average end-to-end delay to 0.3585 s, corresponding to approximately 75% reductions relative to both comparators. It achieved a packet-delivery ratio and normalized throughput of 0.92, full node reachability, an energy-delay product of 0.2035, and an energy-reliability product of 0.6170. The generic multi-objective ACO retained the longest raw network lifetime and the largest hypervolume, whereas the proposed method provided the strongest overall compromise between energy, latency, connectivity, and reliability. The findings support adaptive clustering and Pareto-guided pheromone control as a practical direction for resource-constrained WSNs, while also identifying the need for repeated-seed statistical validation and hardware-in-the-loop assessment.
- References
- Downloads
- Published
- 14-08-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Nsikan L. AKPAN, Akaniyene OBOT, Olusegun A. AFOLABI (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Zaharaddeen MUSA, Aliyu BELLO, Haris A. DANLADI, Design and Construction of Dual Input Mobile Solar Generator for Reliable Off-Grid Power , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Koliya LAAYE, Solomon O. OGUCHE, Ibrahim I. JIDDA, Abdullahi A. ADAMU, Economic Viability of Waste-to-Energy: Pathways for Sustainable Power Generation in Jalingo, Taraba State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Opeyemi O. ASAOLU, Oluwasanmi S. ADANIGBO, Temidayo J. AKINDAHUNSI, Advances in Privacy Preservation Techniques for Mobile Ad Hoc Networks: A Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Benedict O. EDENSETING, Innocent O. OBOH, Alexander A. JOCK, Effective Food Waste Utilization: A Veritable Source of Biofuel for Nigerian Economic Sustenance and Development - A Review , FUDMA Journal of Engineering and Technology: Vol. 1 No. 1 (2025): July 2025
- Abubakar S. MOHAMMED, Mohammed ALIYU, Mohammed U. GARBA, Ibrahim S. MOHAMMED, Ibrahim A. KUTI, Meshack S. IMOLOGIE, Umaru MUSA, Olalekan D. ADENIYI, Peter A. ADEOYE, Abubakar G. ISAH, Folarin T. OLORUNMOTITO, Development and Packaging of Eco-friendly Biosolid Briquettes Synthesised with Bagasse for Green Energy Generation and Utilisation , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Bala ABDULLAHI, Bala G. ABDURRAHMAN, Yusuf ALHASAN, Saidu B. ABUBAKAR, Bashir I. KUNYA, Raya K. ALDADAH, Saad MAHMOUD, Ahmed REZK, Effects of Truncating the Height of Compound Parabolic Collector on its Geometry, Optical and Thermal Performances , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Gbenga G. OSEKE, Chisom S. AMADI, Abubakar U. RAJI, Hydrogen Production from Flare Gas via Steam Methane Reforming: A Simulation-Based Approach , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Oyeyemi T. AFOROLAGBA-BALOGUN, Olumide A. TOWOJU, Characterization of Fuel Produced from Nylon (Polyamide) and Polyethylene Terephthalate (PET) Wastes with Pyrolysis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Nnamdi S. OKOMBA, Adedayo A. SOBOWALE, Adebimpe O. ESAN, Bolaji A. OMODUNBI, Taiwo A. AWOYEMI, Development of a High Blood Pressure and Hypoxemia Measuring Device , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Oluyemi S. ONIFADE, Olusegun O. AJIDE, Development and Performance Evaluation of a Semi-Automated Impact Fracture Tester , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
