Data-Driven Observability Enhancement in Active Distribution Networks via Optimal Co-Deployment of DGs and D-PMUs Using Hybrid APSO-ASDA
- Authors
-
-
Mela I. L. LASHIRU
Author
-
Ganiyu A. BAKARE
Author
-
Sabo M. HASSAN
Author
-
Kamilu O. LAWAL
Author
-
- Keywords:
- Active Distribution Network, D-PMU, Observability, Data-Driven Control, APSO, ASDA, Distribution System State Estimation, Rate-of-Change of Frequency ROCOF.
- Abstract
-
The increasing deployment of renewable Distributed Generators (DGs) introduces operational uncertainty and observability challenges in Active Distribution Networks (ADNs). Traditional Supervisory Control and Data Acquisition (SCADA) systems lack the temporal resolution required for real-time monitoring. This paper proposes a data-driven framework for enhancing network observability through optimal co-deployment of DGs and Distribution Phasor Measurement Units (D-PMUs) using a hybrid Accelerated Particle Swarm Optimization-Adaptive Spiral Dynamic Algorithm (APSO-ASDA). The objective is to maximize network observability with minimal measurement redundancy for improved Distribution System State Estimation (DSSE). Simulation results on the IEEE 13-bus ADN, modeled in MATLAB Simulink R2023b, showed ASDA optimal DG -D-PMU placement at buses 1, 4, with corresponding sizes of 340Kw(solar), and 445kW(wind) with D-PMU at 6, 7, 10, and 12. APSO DG placement is at bus 3 and 4 with a size of 60kW(solar), 400kW(wind), D-PMU at buses 6, 8, 9. The hybrid approach places DG at buses 1 and 3 with corresponding capacities of 110kW (solar) and 250kW (wind), and D-PMU allocation at buses 4, 6, 7, 8, 11 and 12. The hybrid algorithm achieved a rapid reduction in the cost function from 278.7 to 81.14 within the first 36 iterations, highlighting its effectiveness for real-time, data-driven applications.
- References
- Downloads
- Published
- 23-05-2026
- Section
- Articles
- License
-
Copyright (c) 2026 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Ibrahim A. KUTI, Sunday E. OGUNMOLA, Peter A. ADEOYE, Evaluation of the Agricultural Best Management Practices (ABMPs) and Their Effect on Discharge Reduction of Shiroro Dam Site using SWAT Model , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Oluwasanmi S. ADANIGBO, Opeyemi O. ASAOLU, Adedayo A. SOBOWALE, Temidayo AKINDAHUNSI, Akinbayode A. ASAOLU, Intrusion Detection in Mobile Adhoc Networks: A Review of Signature-Based, Anomaly-Based, and Hybrid Approaches , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Kazeem A. BELLO, Adeniyi O. ADESINA, Lukman A. OPEYEMI, Solomon O. UVIASE, Francis O. BOROKINNI, Friday ONUH, Tunde O. OGUNDANA, Adebayo I. OLUMOROTI, Developments and Applications of Additive Manufacturing in the Automotive Industry , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Abdullahi YAHAYA, Ahmad ADO, Jaju A. MUHAMMAD, Zaharaddeen G. SANI, Baba A. OLUWA, Abdulazeez A. YUSUF, Kinetic Modelling of Sonocatalytic Phenol Degradation over Alumina-Supported Copper Oxide Catalyst , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Christopher A. FAPOHUNDA, Strategies for the Revitalization of Civil Engineering Education in Nigeria – An Overview of Vitruvius Ten Book on Architecture , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Mohammed A. GANA, Zaka A. MSHELIA, Isuwa S. AJI, Alhaji GUJJA, Lawan A.M. KOLO, Investigation and Comparative Analysis of Natural Moulding Sands from Five Deposits in Maiduguri, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Sheidu S. ONIMISI, Usman B. ABDULLAHI, Hayatudden S. BARAYAIS, Abubakar M. MUHAMMAD, Abubakar G. ISAH, Abubakar S. MOHAMMED, Mohammed U. GARBA, Safety Evaluation of Orifice Plate in Natural Gas Pipeline using Computer Aided Engineering (CAE): A Step Towards Food Security , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Mohammed U. GARBA, Musa A. ABDULLAHI, Isah RABI, Saadatu A. GORO, Habibu UTHMAN, Abubakar S. MOHAMMED, Umaru AHMADU, Usman S. ONODUKU, Recovery of Lithium Carbonate from Nigerian Lepidolite Ore via Roasting-Leaching-Precipitation , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Joseph A. OJENIYI, Zainab L. BELLO, Ismail IDRIS, Noel M. DOGONYARO, Suleiman AHMAD, Sikiru O. SUBAIRU, Entropy-Based Deep Learning Framework for Classifying Ransomware Families in Windows Environment , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Abdulkabiru A. ABDULRAZAQ, Abideen A. ISMAIL, Muhammad S. NAZRUL-ISLAM, Akeem R. ABIOYE, Margaret D. OKPOR, Paschal, U. CHINEDU, Image Denoising: An Overview of Noise Model, Denoising Methods and Applications , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Emmanuel T. ODEYEMI, Ya’u S. HARUNA, Ganiyu A. BAKARE, Hassan B. MAMMAN, Sabo M. HASSAN, BAT-Optimized PID and ANFIS Torque-Based MPPT for a 0.5 MW PMSG-Based Wind Energy Conversion System Under Dynamic Wind Conditions , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Emmanuel T. ODEYEMI, Ya’u S. HARUNA, Ganiyu A. BAKARE, Hassan B. MAMMAN, Sabo M. HASSAN, Software-in-the-Loop Validation of an Adaptive Particle Swarm Optimization-Based MPPT Controller for Real-Time Photovoltaic System , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Umar A. ADAMU, Ya’u S. HARUNA, Ganiyu A. BAKARE, Buhari H. MAMMAN, Kunduli MUSTAPHA, Hadi M. ADAMU, Ismaila MAHMUD, Design and Simulation of a 200 MWp Floating Solar PV Plant Integrated with the Kainji Hydropower Plant, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
