Experimental Characterization and Seasonal Energy Potential Assessment of Municipal Solid Waste in Kano City, Nigeria
- Authors
-
-
Sirajo ALHASSAN
Author
-
Abdullahi A. ADAMU
Author
-
Mohammed T. JIMOH
Author
-
- Keywords:
- Calorific value; Energy recovery; Municipal solid waste; Seasonal variation; Waste-to-energy.
- Abstract
-
Municipal solid waste (MSW) management remains a critical environmental challenge in rapidly urbanizing regions such as Kano City, Nigeria. This study presents an experimental characterization and energy potential assessment of MSW based on seasonal variation (dry and wet seasons). Representative samples were collected from four major dumping sites: Sallari, Maimalari, Uba Gama, and Hajj Camp. Proximate and ultimate analyses were conducted to determine moisture content, ash content, volatile matter, fixed carbon, and elemental composition (C, H, O, N, and S). The results reveal clear seasonal differences in MSW properties. Moisture content ranged from ≈28.25% in the dry season to ≈44.25% in the wet season, while ash content varied between ≈28.50% and ≈31.50%. Volatile matter increased from ≈19.75% in the wet season to ≈28.40% in the dry season, and fixed carbon ranged from ≈4.50% to ≈14.85%. Ultimate analysis revealed relatively stable elemental composition across seasons, with carbon (≈45.57–46.23%), hydrogen (≈6.49–6.58%), oxygen (≈45.31–46.31%), nitrogen (≈1.42–1.43%), and sulfur (≈0.23–0.24%). These results indicate moderate fuel characteristics with variability influenced by seasonal conditions. The higher heating value (HHV) was estimated to range between ≈16.43 and ≈16.95 MJ/kg, while the lower heating value (LHV) ranged from ≈13.92 to ≈14.82 MJ/kg, with higher values observed during the dry season due to reduced moisture content. The findings suggest that although high moisture and ash contents may limit the efficiency of direct combustion, the waste stream possesses moderate energy recovery potential. Overall, the findings confirm the suitability of MSW in Kano City for thermochemical conversion technologies such as pyrolysis and gasification, particularly with appropriate pre-treatment strategies. This study provides robust, seasonally resolved experimental data for supporting sustainable waste-to-energy planning and decision-making in rapidly growing urban environments.
- References
- Downloads
- Published
- 13-04-2026
- Section
- Articles
- License
-
Copyright (c) 2026 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Jafaru A. MOHAMMED, Thomas N. GUMA, Malachy SUMAILA, Mahdi MAKWAYO, A Review of Local Manufacturing of Borehole Windmill Gear Trains Using Reverse Engineering and Integrated Braking Systems , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Murtala NAMAKKA, Abdulhamid S. ILIYASU, Utilisation of Supercritical Critical Fluids in Adsorption Process: A Comprehensive Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Sarafa ISHOLA, Olusegun S. OLAOYE, Adeyinka A. ADEGBOLA, Isaac A. OLUREMI, Oluseye O. AGBEDE, Drying Kinetics and Combustion Characteristics of Carbonized Cashew Nut Shell Briquettes Under Open Sun, Passive and Active Solar Drying , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Cyril OCHERI, Victor S. AIGBODION, Esther O. AMEH, Ihebuchuwu C. EZEAKU, Chibuikem A. OKAFOR, Uchenna C. AMAZUE, Eddy R. OMONIGHO, Electrochemical Analysis of Azadirachta indica Leaves as a Corrosion inhibitor on Mild Steel in 1 M H2SO4 , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Adekunle A. YEKINNI, Adeniyi O. ADESINA, Kazeem A. BELLO, Effect of Subcritical Tempering on the Microstructural, Mechanical and Corrosion Behaviour of Mild Steel , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Bala I. ABDULKARIM, Yusuf M. BABA, Suleiman I. ENEHE, Kamoru A. SALAM, Umar IDRISS, Synthesis of Activated Carbon from Corncob for the removal of Lead (Pb²⁺) ions from Aqueous solution using a packed bed Adsorption Column , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Abdulkareem BELLO, Yusuf O. ADEIZA, Saleh S. LUKMAN, Muhammad A. ADAMU, Chibuzor A. OKAFOR, Abdulaziz A. ABDULSALAM, Production of Silica from ABU Zaria Dam Sand as an Eco-Friendly Corrosion Inhibitor Using Nanotechnology , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Oluwaseun S. OGUNGBEMI, Aquifer Characterisation and Vulnerability Assessment in a Typical Basement Complex Terrain , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Isiaq O. ALABI, Hassan T. ABDULAZEEZ, Sulaiman AHMAD, Yahaya M. SANI, Scalability Versus Accuracy Trade-offs in Distributed Big Data Processing Frameworks: A Comparative Evaluation of Apache Spark, Flink, and Dask Using Benchmark Datasets , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Chukwuemeka S. IBEH, Abubakre O. KAMARDEEN, Saka A. ABDULKAREEM, Aliyu A. ABDULLAHI, Experimental Study on the Characterisation and Thermo-Physical Properties of Graphene-Agro Based Hybrid Nanofluids , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Sirajo ALHASSAN, Abdullahi A. ADAMU, Mohammed T. JIMOH, Multi-Criteria Decision Analysis and Optimization Approaches in Sustainable Waste-to-Energy Planning: A Systematic Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Koliya LAAYE, Solomon O. OGUCHE, Ibrahim I. JIDDA, Abdullahi A. ADAMU, Economic Viability of Waste-to-Energy: Pathways for Sustainable Power Generation in Jalingo, Taraba State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
