Experimental Characterization and Seasonal Energy Potential Assessment of Municipal Solid Waste in Kano City, Nigeria
- Authors
-
-
Sirajo ALHASSAN
Author
-
Abdullahi A. ADAMU
Author
-
Mohammed T. JIMOH
Author
-
- Keywords:
- Calorific value; Energy recovery; Municipal solid waste; Seasonal variation; Waste-to-energy.
- Abstract
-
Municipal solid waste (MSW) management remains a critical environmental challenge in rapidly urbanizing regions such as Kano City, Nigeria. This study presents an experimental characterization and energy potential assessment of MSW based on seasonal variation (dry and wet seasons). Representative samples were collected from four major dumping sites: Sallari, Maimalari, Uba Gama, and Hajj Camp. Proximate and ultimate analyses were conducted to determine moisture content, ash content, volatile matter, fixed carbon, and elemental composition (C, H, O, N, and S). The results reveal clear seasonal differences in MSW properties. Moisture content ranged from ≈28.25% in the dry season to ≈44.25% in the wet season, while ash content varied between ≈28.50% and ≈31.50%. Volatile matter increased from ≈19.75% in the wet season to ≈28.40% in the dry season, and fixed carbon ranged from ≈4.50% to ≈14.85%. Ultimate analysis revealed relatively stable elemental composition across seasons, with carbon (≈45.57–46.23%), hydrogen (≈6.49–6.58%), oxygen (≈45.31–46.31%), nitrogen (≈1.42–1.43%), and sulfur (≈0.23–0.24%). These results indicate moderate fuel characteristics with variability influenced by seasonal conditions. The higher heating value (HHV) was estimated to range between ≈16.43 and ≈16.95 MJ/kg, while the lower heating value (LHV) ranged from ≈13.92 to ≈14.82 MJ/kg, with higher values observed during the dry season due to reduced moisture content. The findings suggest that although high moisture and ash contents may limit the efficiency of direct combustion, the waste stream possesses moderate energy recovery potential. Overall, the findings confirm the suitability of MSW in Kano City for thermochemical conversion technologies such as pyrolysis and gasification, particularly with appropriate pre-treatment strategies. This study provides robust, seasonally resolved experimental data for supporting sustainable waste-to-energy planning and decision-making in rapidly growing urban environments.
- References
- Downloads
- Published
- 13-04-2026
- Section
- Articles
- License
-
Copyright (c) 2026 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Isiaq O. ALABI, Hassan T. ABDULAZEEZ, Sulaiman AHMAD, Yahaya M. SANI, Scalability Versus Accuracy Trade-offs in Distributed Big Data Processing Frameworks: A Comparative Evaluation of Apache Spark, Flink, and Dask Using Benchmark Datasets , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Chukwuemeka S. IBEH, Abubakre O. KAMARDEEN, Saka A. ABDULKAREEM, Aliyu A. ABDULLAHI, Experimental Study on the Characterisation and Thermo-Physical Properties of Graphene-Agro Based Hybrid Nanofluids , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Christopher A. FAPOHUNDA, Strategies for the Revitalization of Civil Engineering Education in Nigeria – An Overview of Vitruvius Ten Book on Architecture , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Sulaiman Y. ADAMU, Fadimatu N. DABAI, Abdulazeez Y. ATTA, Baba Y. JIBRIL, Preparation and Characterization of Enhanced Hierarchical Zn-Ni/HZSM-5 Catalysts for Potential use in Catalytic reactions to Upgrade Bio-Oil and Hydrogen from Biomass Pyrolysis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Kazeem A. BELLO, Adeniyi O. ADESINA, Lukman A. OPEYEMI, Solomon O. UVIASE, Francis O. BOROKINNI, Friday ONUH, Tunde O. OGUNDANA, Adebayo I. OLUMOROTI, Developments and Applications of Additive Manufacturing in the Automotive Industry , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Yetunde M. ALADEITAN, Abdulmojeed O. OLUOGUN, Potential of Zinc Oxide Nanoparticles for Remediation of Oil-Contaminated Soil and Water , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Ahmad IDRIS, Evaluation of Challawa Tannery Wastewater as Mixing and Curing Water for Concrete Production , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Ephraim G. KEFAS, Abdulfatai JIMOH, Mohammed A. EVUTI, Abubakar A. IBRAHIM, Abdulwahab GIWA, Adeola G. OLUGBENGA, Luffa Sponge, Banana Stem and Delonix regia Seed Characterization as Potential Biosorbents for Industrial Wastewater Remediation , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Cletus C. OPUTE, Obumneme O. OKWONNA, Comparative Analysis on the Efficiencies of Unmodified Clay and Microorganism-Modified Clay as Adsorbent for the Adsorption of Lead (II) Ions from Wastewater , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Sirajo ALHASSAN, Abdullahi A. ADAMU, Mohammed T. JIMOH, Multi-Criteria Decision Analysis and Optimization Approaches in Sustainable Waste-to-Energy Planning: A Systematic Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Koliya LAAYE, Solomon O. OGUCHE, Ibrahim I. JIDDA, Abdullahi A. ADAMU, Economic Viability of Waste-to-Energy: Pathways for Sustainable Power Generation in Jalingo, Taraba State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
