Design and Implementation of IOT-Based Intravenous (IV) Bag Monitoring and Alert System
- Authors
-
-
Gregory T. AKAU
Department of Electrical/Electronics, Nigerian Defence Academy, Kaduna, Nigeria
Author
-
Abel AIROBOMAN
Department of Electrical/Electronics, Nigerian Defence Academy, Kaduna, Nigeria
Author
-
Nathaniel DALLA
Department of Electrical/Electronics, Nigerian Defence Academy, Kaduna, Nigeria
Author
-
- Keywords:
- Intravenous (IV) monitoring, IoT-based healthcare, Arduino Uno, drip rate monitoring, ESP8266 Wi-Fi, ThingSpeak cloud, hospital automation.
- Abstract
-
Health, being a critical aspect of daily life, demands heightened attention, especially when a patient is hospitalized. In densely populated hospitals with limited nursing staff, the continuous monitoring of Intravenous (IV) fluid becomes a challenge. If the IV fluid is not properly monitored, severe consequences may arise, such as blood reflux or the entry of air bubbles into the patient's bloodstream when the fluid bottle runs dry. To address this, the project proposes the design and implementation of an IoT-based intravenous infusion monitoring and Alert System using the Huamao Communication 12 radio frequency module (HC-12) for wireless communication. The system also integrates Espressif Wi-Fi SoC ESP8266 wi-fi connectivity for real-time data transmission to the ThinkSpeak cloud platform. The hardware setup includes a load cell with an HX711 interface for continuous measurement of the IV fluid's weight, and a laser sensor positioned on the drip chamber to monitor the droplet rate. An Arduino Uno microcontroller coordinates the sensors and decision logic. When the fluid level drops below a critical threshold or the drip rate becomes abnormal, an alert is transmitted wirelessly via the RF module to a remote receiver unit (e.g., nurse’s station), where the patient's information and alert status are displayed. Additionally, the ESP8266 module uploads real-time data to the internet for remote monitoring and analytics. The performance evaluation of the prototype demonstrated a system success rate of approximately 96.8% in accurately detecting both low-fluid and abnormal drip rates. This low-cost, easily deployable system enhances patient safety by ensuring timely intervention from medical staff and is particularly suited for resource-constrained hospitals that cannot afford expensive commercial IV monitoring system.
- References
- Downloads
- Published
- 15-11-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Onyeka E. NNANYELUGO, Peter O. OFFOR, Cyril OCHERI, Camillus S. OBAYI, Optical and Structural Properties of Er/Sr Co-Doped αMnS Films Prepared by Chemical Spray Pyrolysis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Fatima A. MUSA, Abdulmajid B. UMAR, Abba M. BALA, A Hybrid CNN–BiGRU Model with Grey Wolf Optimization and LightGBM for Stock Price Prediction , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Bala I. ABDULKARIM, Yusuf M. BABA, Suleiman I. ENEHE, Kamoru A. SALAM, Umar IDRISS, Synthesis of Activated Carbon from Corncob for the removal of Lead (Pb²⁺) ions from Aqueous solution using a packed bed Adsorption Column , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Isiaq O. ALABI, Hassan T. ABDULAZEEZ, Sulaiman AHMAD, Yahaya M. SANI, Scalability Versus Accuracy Trade-offs in Distributed Big Data Processing Frameworks: A Comparative Evaluation of Apache Spark, Flink, and Dask Using Benchmark Datasets , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Tolulope S. FAWALE, Monday O. IMAFIDON, Chukwuemeka P. OGBU, Adoption of Non-Financial Motivational Strategies for Enhancing Productivity on Construction Sites in Edo State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Cletus C. OPUTE, Obumneme O. OKWONNA, Comparative Analysis on the Efficiencies of Unmodified Clay and Microorganism-Modified Clay as Adsorbent for the Adsorption of Lead (II) Ions from Wastewater , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Zakariah A. ADEJOH, Hawawu SALAMI, Abdullahi M. EVUTI, Yahaya S. MOHAMMAD, Yakubu STEPHEN, Effect of Activation Time on Physicochemical Properties of Activated Carbon Prepared from Coconut Shell , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Lucas A. J. HAMIDU, Microscopic Characterization of Optimized Particleboards Made from Softwood Sawdust and Rice Husk Using Optimized Polystyrene Waste Adhesive , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Shamsuddeen J. AHMAD, Saifullahi S. SADI, Muhammad M. AHMAD, Abdullahi D. UMAR, Shamsuddeen USMAN, Comparative Analysis of Machine Learning Algorithms for the Detection and Classification of Suspicious Emails , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Murtala NAMAKKA, Abdulhamid S. ILIYASU, Utilisation of Supercritical Critical Fluids in Adsorption Process: A Comprehensive Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
