Economic Viability of Waste-to-Energy: Pathways for Sustainable Power Generation in Jalingo, Taraba State, Nigeria
- Authors
-
-
Koliya LAAYE
Department of Mechanical Engineering, Faculty of Engineering, Bayero University, Kano, Nigeria
Author
-
Solomon O. OGUCHE
Department of Biochemistry, Faculty of Basic Medical Sciences, Bayero University, Kano, Nigeria
Author
-
Ibrahim I. JIDDA
Department of Mechanical Engineering, Faculty of Engineering, Bayero University, Kano, Nigeria
Author
-
Abdullahi A. ADAMU
Department of Mechanical Engineering, Faculty of Engineering, Bayero University, Kano, Nigeria
Author
-
- Keywords:
- Incineration, landfill gas, LCOE, techno-economic, waste-to-energy.
- Abstract
-
This study evaluates the technical and economic viability of waste-to-energy (WtE) technologies for sustainable electricity generation in Jalingo metropolis, Taraba State, Nigeria. Two WtE pathways were assessed: (i) thermal conversion through incineration with power generation, and (ii) landfill gas (LFG) capture with reciprocating engines. Locally reported municipal solid waste (MSW) data and performance-cost ranges from literature were applied to estimate electricity potential, installed capacity, levelized cost of electricity (LCOE), net present value (NPV), and internal rate of return (IRR). The waste composition was dominated by plastics (29.67–34.67%) and agricultural residues (28–29%), followed by paper/cardboard (9.88–11.93%), textiles (4.04–9.20%), and food waste (5.66–6%). Metals (0.42–1.11%) and glass (0.90–1.30%) constituted the smallest fractions. Moisture content ranged from 25.40% at Mile Six dumpsite to 28.98% at Pantinapu; volatile matter peaked at 38.84% at Mile Six. Heat values between 6.32 and 6.68 MJ/kg confirmed the technical feasibility of incineration-based energy recovery. Electricity generation potential was estimated at 39,417.74 kWh/day from incineration and 1,644,106.24 MWh/year (≈4.5 million kWh/day) from LFG, capable of supplying approximately 17,127 and 1,957 households respectively, based on average household consumption of 840 kWh/year. Economic analysis revealed positive NPVs ($1.20–1.45 million) and IRRs of 18–79% at a tariff of N250/kWh (US $0.15), demonstrating profitability. Environmental assessment indicated that methane combustion for electricity reduced carbon dioxide emissions by about 88.18% compared to uncontrolled waste disposal. The findings highlight that municipal solid waste in Jalingo possesses sufficient energy content to support WtE initiatives. Both incineration and LFG capture not only offer substantial electricity generation potential but also present economically viable and environmentally sustainable alternatives to current waste management practices.
- References
- Downloads
- Published
- 06-10-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Mathew O. ADEOTI, Victor N. HARUNA, Omolayo M. IKUMAPAYI, Timothy A. ADEKANYE, Development and Characterization of Epoxy-Based Asbestos-Free Brake Pad Composites Reinforced with Cow Hoof Particulates , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Damilare L. ADEKEYE, Uche M. IROKA, A Microcontroller-Based Intelligent Electricity Theft Detection and Prevention System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Habib I. ABDULAZEEZ, Bala ABDULLAHI, Abdullahi AHMED, Ibrahim A. TUKUR, Experimental Investigation of Solar Photovoltaic Tilt Angles for Maximum Energy Harvest in Kogi State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Sheidu S. ONIMISI, Usman B. ABDULLAHI, Hayatudden S. BARAYAIS, Abubakar M. MUHAMMAD, Abubakar G. ISAH, Abubakar S. MOHAMMED, Mohammed U. GARBA, Safety Evaluation of Orifice Plate in Natural Gas Pipeline using Computer Aided Engineering (CAE): A Step Towards Food Security , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Ismaila MAHMUD, Mahmud MUSTAPHA, Sulaiman H. SULAIMAN, Ibrahim ABDULWAHAB, Ibrahim A. SHEHU, Aminu J. ALIYU, Yusuf S. ABU, Nuraddeen A. ILIYASU, Solar Irradiance Forecast using Feed Forward Neural Network: A Case Study of Zaria Town , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Suleiman ZUBAIR, Hassan ABDULAZEEZ, Bala A. SALIHU, Abubakar A. SHUAIBU, Design and Implementation of a BLE 5.0-Enabled Wearable Finger Mouse Using the XIAO nRF52840 Platform , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Auwalu M. ABDULLAHI, Musa M. BELLO, Ado HARUNA, Amina I. KHALEEL, Lubabatu B. ILA, Abdurrahaman M. BELLO, Adaptive Hybrid Compliant Control of a Desktop Upper-Limb Rehabilitation Robot , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Bala I. ABDULKARIM, Umar IDRISS, Synthesis and Characterization of Laggera aurita-Derived KOH Activated Carbon (LAKOHAC) and Role for the Adsorption of Water-Soluble Fraction of Benzene (WSFB) in Oil-Spilled Water , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Hyelni G. MSHELIA, Abdulfatai JIMOH, Mohammed A. EVUTI, Abubakar A. IBRAHIM, Abdulwahab GIWA, Adeola G. OLUGBENGA, Potential of Onion Skin, Luffa cylindrica, and Corn Cob as Cellulose Sources: A Study of Their Proximate, Ultimate, and Morphological Properties , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Peter EDOKA, Assessment of the Role of Kogi State Government in Flood Mitigation in Lokoja, Kogi State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Sirajo ALHASSAN, Abdullahi A. ADAMU, Mohammed T. JIMOH, Multi-Criteria Decision Analysis and Optimization Approaches in Sustainable Waste-to-Energy Planning: A Systematic Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Sirajo ALHASSAN, Abdullahi A. ADAMU, Mohammed T. JIMOH, Experimental Characterization and Seasonal Energy Potential Assessment of Municipal Solid Waste in Kano City, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
