Techno-Economic and Environmental Assessment of a Solar PV-Based Microgrid for Residential Electrification in Gwange I, Maiduguri Using HOMER Pro
- Authors
-
-
Muhammad M. HAMIDU
Department of Mechanical Engineering, University of Maiduguri, Maiduguri, Nigeria
Author
-
Mathew KATAMBI
Department of Mechanical Engineering, University of Maiduguri, Maiduguri, Nigeria
Author
-
Omar FARUQ
Department of Mechanical Engineering, University of Maiduguri, Maiduguri, Nigeria
Author
-
- Keywords:
- Solar PV microgrid, battery energy storage, techno-economic optimization, Homer Pro software.
- Abstract
-
The Nigerian power sector continues to struggle with outdated infrastructure, security related disruption, climate change disruptions, and unstable grid supply. In densely populated areas like Gwange I Ward, Maiduguri, centralized electricity systems remain inadequate, forcing residents to depend on costly diesel and petrol generators. This study aims to address this issue by optimizing a solar photovoltaic (PV)–battery energy storage system (BESS) microgrid. The system for Gwange I was designed and optimized using HOMER Pro v3.14, integrating load estimation, solar resource analysis, component sizing, technical performance and economic analysis into the methodological framework. Simulation results indicate that the proposed configuration comprising a 1,085 kW PV array and 1,172 kWh of usable battery storage achieves renewable penetration above 660% and delivers an annual generation of approximately 1.95 GWh. The system's competitiveness against diesel alternatives is confirmed by economic analysis, with a levelized cost of energy (LCOE) of ₦28.68/kWh and a payback period of 2.3 years. The study also highlights the importance of thermal effects on system performance, revealing a 2.7% drop in annual PV output due to temperature increase. Environmentally, noise and air pollution are reduced, and annual CO₂ emissions are reduced by over 1,300 metric tonnes. The study confirms that decentralized solar microgrids with resilience-focused design offer a sustainable, reliable route to urban electrification in weak and climate-sensitive contexts, thus directing policy for microgrid deployment and integration of thermal management.
- References
- Downloads
- Published
- 22-09-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Suleiman ZUBAIR, Hassan ABDULAZEEZ, Bala A. SALIHU, Abubakar A. SHUAIBU, Design and Implementation of a BLE 5.0-Enabled Wearable Finger Mouse Using the XIAO nRF52840 Platform , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Amina UTHMAN, Shamsuddeen SULAIMAN, Evaluation of Cost Factors Influencing the Adoption of Sustainable Construction Practices in Abuja, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Babagoni A. ADAM, Muhammad B. MAINA, Muhammad SHUWA, Abba B. MUHAMMAD, A Review on Neem Leaves Valorization Through Advanced Briquetting and Carbonization Technologies , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Murtala NAMAKKA, Abdulhamid S. ILIYASU, Utilisation of Supercritical Critical Fluids in Adsorption Process: A Comprehensive Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Sulaiman Y. ADAMU, Fadimatu N. DABAI, Abdulazeez Y. ATTA, Baba Y. JIBRIL, Preparation and Characterization of Enhanced Hierarchical Zn-Ni/HZSM-5 Catalysts for Potential use in Catalytic reactions to Upgrade Bio-Oil and Hydrogen from Biomass Pyrolysis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Sati C. NSHOL, Saeed Y. UMAR, Suleiman A. YERO, Modification of the Engineering Properties of Road Base Course Soil Materials with Cement and Polyethylene Terephthalate (PET) , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Mohammed U. GARBA, Musa A. ABDULLAHI, Isah RABI, Saadatu A. GORO, Habibu UTHMAN, Abubakar S. MOHAMMED, Umaru AHMADU, Usman S. ONODUKU, Recovery of Lithium Carbonate from Nigerian Lepidolite Ore via Roasting-Leaching-Precipitation , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Victor A. NSABA, Sabiu B. YUSUF, Kafayat A. IBRAHIM, Consumer Perceptions of Artificial Intelligence (AI)-Driven Smart Grids and Energy Efficiency in Northwest Nigeria’s Power Distribution Sector: A Multi-State Case Study of Sokoto, Kebbi, and Zamfara , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Sirajo ALHASSAN, Abdullahi A. ADAMU, Mohammed T. JIMOH, Experimental Characterization and Seasonal Energy Potential Assessment of Municipal Solid Waste in Kano City, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Aliu S. SALIU, Ejike C. ANENE, Buhari M. HASSAN, Sabo M. HASSAN, Salisu H. MOHAMMED, Nafisa S. USMAN, Addressing Resource Allocation Challenges in Wireless Networks with Cultural Smell Agent Optimization Algorithms: A Literature Survey , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Hafsah A. ABDULRAHMAN, Muhammad M. HAMIDU, Techno-Economic Optimization of a Hybrid PV-Wind-Waste-to Energy System for the University of Maiduguri , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammad M. HAMIDU, Development of MATLAB-Based Model for Solar Radiation Prediction and Photovoltaic Panel Tilt Optimization Angle for Maiduguri Region, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammad M. HAMIDU, Abubakar M. EL-JUMMAH, Muhammad SHUWA, An Assessment of Power Sources for Improved Energy Supply in University of Maiduguri , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
