Treatment of Gold Mining Wastewater: A Review of Current Technologies and Future Perspectives
- Authors
-
-
Mohammed U. GARBA
Department of Petroleum and Gas Engineering, Federal University of Technology, Minna, Nigeria
Author
-
Usman B. ABDULLAHI
Department of Petroleum and Gas Engineering, Federal University of Technology, Minna, Nigeria
Author
-
Hayatudden S. BARAYAIS
Department of Petroleum and Gas Engineering, Federal University of Technology, Minna, Nigeria
Author
-
Aisha B. FARUQ
Department of Petroleum and Gas Engineering, Federal University of Technology, Minna, Nigeria
Author
-
Suleiman IDRIS
Department of Chemistry, Federal University of Technology, Minna, Nigeria
Author
-
Abubakar M. MUHAMMAD
Department of Petroleum and Gas Engineering, Federal University of Technology, Minna, Nigeria
Author
-
Abubakar S. MOHAMMED
Department of Agricultural and Bio-Environmental Engineering, Federal University of Technology, Minna, Nigeria
Author
-
- Keywords:
- Gold mining, heavy metals, technologies, treatment, wastewater.
- Abstract
-
Gold mining wastewater poses significant environmental risks due to its complex composition, including high concentrations of heavy metals, cyanide, sulphates, and acidic discharges. Effective treatment before release into the environment is essential to prevent long-term ecological and public health damage. This manuscript reviews the environmental impacts of gold mining wastewater and highlights current industrial-scale treatment technologies such as SAVMIN (Sulphate Removal Process), Slurry Precipitation and Recycle Reverse Osmosis (SPARRO), Biogenic Sulphide, and DESALX, which have been successfully commercialised in gold mining operations. These technologies integrate multiple separation processes for the efficient recovery of salts and over 95% of water for reuse, supporting sustainable mining practices. In addition, the study presents modern pilot-stage systems and laboratory-scale methods, particularly adsorption-based technologies, developed for the removal and recovery of precious and toxic metals from gold mine effluents. While many adsorbents have shown high removal efficiency, challenges remain in terms of adsorbent reusability, toxic sludge management, and economic feasibility. The need for integrating treatment systems that enable the simultaneous reclamation of water and recovery of gold and other valuable metals at low concentrations is emphasised as a step toward circular mine water use. The study concludes that for long-term sustainability, future gold mining wastewater treatment must address not only contaminant removal but also resource recovery, waste minimisation, and cost-effectiveness.
- References
- Downloads
- Published
- 22-09-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Bala I. ABDULKARIM, Yusuf M. BABA, Suleiman I. ENEHE, Kamoru A. SALAM, Umar IDRISS, Synthesis of Activated Carbon from Corncob for the removal of Lead (Pb²⁺) ions from Aqueous solution using a packed bed Adsorption Column , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Mohammed U. GARBA, Musa A. ABDULLAHI, Isah RABI, Saadatu A. GORO, Habibu UTHMAN, Abubakar S. MOHAMMED, Umaru AHMADU, Usman S. ONODUKU, Recovery of Lithium Carbonate from Nigerian Lepidolite Ore via Roasting-Leaching-Precipitation , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Kazeem A. BELLO, Adeniyi O. ADESINA, Lukman A. OPEYEMI, Solomon O. UVIASE, The Impact of Industry 4.0 on New Product Development in Small and Medium Enterprises: A Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Ukange N. SYBIL, Hadiza A. UMAR, Ogar M. OKO, Habeebah A. KAKUDI, Usman MAHMUD, Alex AARON, Leveraging Quantum Machine Learning for Early Ovarian Cancer Diagnosis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Sulaiman Y. ADAMU, Fadimatu N. DABAI, Abdulazeez Y. ATTA, Baba Y. JIBRIL, Preparation and Characterization of Enhanced Hierarchical Zn-Ni/HZSM-5 Catalysts for Potential use in Catalytic reactions to Upgrade Bio-Oil and Hydrogen from Biomass Pyrolysis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Aminu BALA, Nasiru B. KADANDANI, Isiyaku ABUBAKAR, Performance Evaluation of Fuzzy Logic and Fractional Order PI Controllers for Electric Vehicle Wireless Charging System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Peter EDOKA, Incidents of Flood Disaster in Kaduna: Preventive and Mitigating Measures , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Aliu S. SALIU, Ejike C. ANENE, Buhari M. HASSAN, Sabo M. HASSAN, Salisu H. MOHAMMED, Nafisa S. USMAN, Addressing Resource Allocation Challenges in Wireless Networks with Cultural Smell Agent Optimization Algorithms: A Literature Survey , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Samaila J. EL-PATEH, Ibrahim IDRIS, Waste Management in Bauchi Metropolis: Solid Measure and Characterization in Municipality , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Olabanji M. KADI, Sustainability in Construction: A Quantity Surveyor's Perspective on Green Building Practices , FUDMA Journal of Engineering and Technology: Vol. 1 No. 1 (2025): July 2025
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Abubakar S. MOHAMMED, Mohammed ALIYU, Mohammed U. GARBA, Ibrahim S. MOHAMMED, Ibrahim A. KUTI, Meshack S. IMOLOGIE, Umaru MUSA, Olalekan D. ADENIYI, Peter A. ADEOYE, Abubakar G. ISAH, Folarin T. OLORUNMOTITO, Development and Packaging of Eco-friendly Biosolid Briquettes Synthesised with Bagasse for Green Energy Generation and Utilisation , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Sheidu S. ONIMISI, Usman B. ABDULLAHI, Hayatudden S. BARAYAIS, Abubakar M. MUHAMMAD, Abubakar G. ISAH, Abubakar S. MOHAMMED, Mohammed U. GARBA, Safety Evaluation of Orifice Plate in Natural Gas Pipeline using Computer Aided Engineering (CAE): A Step Towards Food Security , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Mohammed U. GARBA, Musa A. ABDULLAHI, Isah RABI, Saadatu A. GORO, Habibu UTHMAN, Abubakar S. MOHAMMED, Umaru AHMADU, Usman S. ONODUKU, Recovery of Lithium Carbonate from Nigerian Lepidolite Ore via Roasting-Leaching-Precipitation , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
