Experimental Investigation of Solar Photovoltaic Tilt Angles for Maximum Energy Harvest in Kogi State, Nigeria
- Authors
-
-
Habib I. ABDULAZEEZ
Rural Electrification Agency (REA), Abuja, Nigeria
Author
-
Bala ABDULLAHI
Department of Mechanical Engineering, Aliko Dangote University of Science and Technology, Wudil, Kano State, Nigeria
Author
-
Abdullahi AHMED
Department of Mechanical Engineering, Aliko Dangote University of Science and Technology Wudil, Kano State, Nigeria
Author
-
Ibrahim A. TUKUR
Department of Mechanical Engineering, Aliko Dangote University of Science and Technology, Wudil, Kano State, Nigeria
Author
-
- Keywords:
- Solar photovoltaic (PV) panels, tilt angle optimization, solar radiation, Kogi State, Nigeria.
- Abstract
-
This study aimed to investigate the impact of tilt angles on solar radiation, current, voltage, and power output of a photovoltaic system, while also employing mathematical modeling to predict solar radiation. This study experimentally investigates the effect of tilt angle (0°, 7.8°, 22.8°, 37.8°, and 52.8°) on the performance of 10W polycrystalline solar panels in Kogi State, Nigeria, over a 12-month period (November 2023–October 2024). Solar radiation, current, and power output were measured at 20-minute intervals using data loggers, voltmeters, and ammeters. The study only investigates the effect of tilt angle and does not consider other factors that may impact solar panel efficiency, such as dust accumulation, temperature, or shading. Results show that optimal performance varies seasonally: lower angles (0°–7.8°) yielded higher radiation and power during peak dry seasons (e.g., November, 613.67 W/m² at 22.8°), while steeper angles (22.8°–37.8°) performed better in transitional months. The 7.8° tilt achieved the highest yearly average radiation, whereas the 0° tilt produced the highest average current (0.300 A) and power (4.51 W). These findings suggest that adjusting tilt angles seasonally can maximize solar energy efficiency in Kogi State, with 7.8° recommended as the best annual fixed tilt.
- References
- Downloads
- Published
- 08-08-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Tolulope S. FAWALE, Monday O. IMAFIDON, Chukwuemeka P. OGBU, Adoption of Non-Financial Motivational Strategies for Enhancing Productivity on Construction Sites in Edo State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammed A. ADAWUDI, Danlami MALIKI, Ibrahim M. ABDULLAHI, Electric Fish Optimizer-Based Hyperparameter Tuning of MLP for Fault Diagnosis in Grid-Connected Photovoltaic Systems , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Luqman K. SALATI, Sani D. MUHAMMAD, Jacob T. ADEYEMO, Simulation of Trucks Haulage Operation at Ashaka Cement Company in Gombe State, North-Eastern Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Victor A. NSABA, Sabiu B. YUSUF, Kafayat A. IBRAHIM, Consumer Perceptions of Artificial Intelligence (AI)-Driven Smart Grids and Energy Efficiency in Northwest Nigeria’s Power Distribution Sector: A Multi-State Case Study of Sokoto, Kebbi, and Zamfara , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Abdulrahman S. USMAN, Folorunsho ABERUAGBA, Moses A. OLUTOYE, Umar MUSA, Mohammed ALHASSAN, Calcium Oxide Derived from Okpella Limestone as a Heterogeneous Catalyst for Biodiesel Production: Synthesis, Characterisation and Stability Assessment , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Koliya LAAYE, Solomon O. OGUCHE, Ibrahim I. JIDDA, Abdullahi A. ADAMU, Economic Viability of Waste-to-Energy: Pathways for Sustainable Power Generation in Jalingo, Taraba State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Oluwayinka. G. AKINWAMIDE, Olugbenga O. AMU, Christopher FAPOHUNDA, Prediction of International Roughness Index of Flexible Pavement Using Machine Learning-Based Predictive Framework in Ekiti State , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Sati C. NSHOL, Saeed Y. UMAR, Suleiman A. YERO, Modification of the Engineering Properties of Road Base Course Soil Materials with Cement and Polyethylene Terephthalate (PET) , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Olabanji M. KADI, Sustainability in Construction: A Quantity Surveyor's Perspective on Green Building Practices , FUDMA Journal of Engineering and Technology: Vol. 1 No. 1 (2025): July 2025
- Usman A. ALI, Munir A. ADEWOYE, Adamu U. ABDULLAHI, Determinants of Blockchain Adoption for Academic Certificate Verification: Insights from Verification Officers for Sustainable Education in Nigerian Higher Education Institutions , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
