Comparative Study of Thermal, Catalyst-Mediated, Biomass-Assisted, and Combined Upgrading Routes for Nigerian Bitumen over a Hierarchical CoMo/ZSM-5 Zeolite Catalyst
- Authors
-
-
Fadimatu N. DABAI
Author
-
Abdulkadir M. SANI
Author
-
Abdulwasiu ABDURRAHMAN
Author
-
- Keywords:
- Bitumen upgrading; heavy oil; CoMo/ZSM-5 catalyst; rice husk biomass; thermal cracking; API gravity.
- Abstract
-
Heavy oil and bitumen tend to be thick, dense, and low in API gravity, and those properties make them more expensive to extract, transport, and refine than conventional crude. This study looked at upgrading Nigerian bitumen using four different approaches: thermal cracking on its own, a hierarchical CoMo/ZSM-5 zeolite catalyst, rice husk biomass acting as a hydrogen donor, and a combined catalyst and biomass system. Each run took place in a batch reactor, with temperature raised from 25 to 350°C under an inert nitrogen atmosphere and then held for 3 hours. The upgraded products were checked for viscosity, density, and API gravity, and both the evolved gas stream and the liquid products were analyzed using Gas chromatography mass spectrometry (GCMS) and Fourier transform infrared (FTIR) spectroscopy. Viscosity dropped sharply, from 28,700 mPa s in the raw feed, down to 285.0, 91.0, 84.6, and 38.2 mPa s for the thermal, catalyst, biomass, and combined runs. API gravity rose from 7.0° to 43.2°, 40.2°, 48.5° and 12.9° across those same runs. Methane showed up as the dominant gas in every case, peaking at 57.1% around the 17 min mark in the catalyst only run. GCMS analysis showed that oxygenated alcohols dominated the thermal and catalyst runs, while carboxylic acids and alkanoate esters dominated the biomass runs; FTIR confirmed oxygenated and aliphatic groups throughout all the products. Taken together, the results show rice husk biomass and the CoMo/ZSM-5 catalyst each improve bitumen's flow properties on their own, but combining them led to an unexpected drop in API gravity, a result that calls for closer mechanistic study.
- References
- Downloads
- Published
- 17-10-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Fadimatu N. DABAI, Abdulkadir M. SANI, Abdulwasiu ABDURRAHMAN (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Chioma I. MADUEKE, Reginald UMUNAKWE, Oluwole D. ADIGUN, An Evaluation of the Porosity and Pore Volume Fractions of Coir Fibres in Relation to Their Diameters and Tensile Properties at a Crosshead Displacement Rate of 0.5 mm/Minute for Composite Applications , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Emmanuel T. ODEYEMI, Ya’u S. HARUNA, Ganiyu A. BAKARE, Hassan B. MAMMAN, Sabo M. HASSAN, BAT-Optimized PID and ANFIS Torque-Based MPPT for a 0.5 MW PMSG-Based Wind Energy Conversion System Under Dynamic Wind Conditions , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Martins Y. OTACHE, Iyanda M. ANIMASHAUN, Sadeeq A. MOHAMMED, Emmanuel O. AGBESE, Spatiotemporal Variability and Trend Analysis of Rainfall and Temperature in Northern Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 1 (2025): July 2025
- Bala YAHAYA, Characterization of Soil Quality Parameters in Sector 2 of Watari Irrigation Project, Kano , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Michael R. ADU, Blessing O. UMUKORO, Design and Construction of a 1.5 kVA Pure Sine Wave Inverter for Office Use , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Sati C. NSHOL, Saeed Y. UMAR, Suleiman A. YERO, Modification of the Engineering Properties of Road Base Course Soil Materials with Cement and Polyethylene Terephthalate (PET) , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Suleiman ZUBAIR, Hassan T. ABDULAZEEZ, Bala A. SALIHU, Gambo MOHAMMED, A Low-Cost, Offline-Capable Wireless Soil Moisture Monitoring System for Smallholder Farmers: Design, Validation, and Agronomic Impact , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Shehu S. SHEHU, Samuel O. OLADIPUPO, Dominic S. NYITAMEN, Simulation and Performance Analysis of a Military Insignia Microstrip Patch Antenna at 2.45 GHz For Wireless Applications , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Fatima A. MUSA, Abdulmajid B. UMAR, Abba M. BALA, A Hybrid CNN–BiGRU Model with Grey Wolf Optimization and LightGBM for Stock Price Prediction , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Stephen YAKUBU, Baba MAKUN, Effect of Petroleum Contamination on Soil Properties and the Removal Efficiency of Volatile Organic Compounds Using Air-Stripping System , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Sulaiman Y. ADAMU, Fadimatu N. DABAI, Abdulazeez Y. ATTA, Baba Y. JIBRIL, Preparation and Characterization of Enhanced Hierarchical Zn-Ni/HZSM-5 Catalysts for Potential use in Catalytic reactions to Upgrade Bio-Oil and Hydrogen from Biomass Pyrolysis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Ojochide P. DAMIAN, Fadimatu N. DABAI, Abdulwasiu ABDURRAHMAN, Kamiludeen OLANREWAJU, Bilyamin ABDULMUMIN, Grace A. OLUGBENGA, A Simulation-Driven Strategy for Improved Expandable Polystyrene Synthesis via Multi-Stage Initiator Dosing , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
