Smart Fence for Real-Time Farm Protection in Sub-Saharan Africa Using Artificial Intelligence: A Systematic Review and Research Roadmap
- Authors
-
-
Omokhafe J. TOLA
Author
-
James G. AMBAFI
Author
-
Umar S. DAUDA
Author
-
- Keywords:
- Initial void ratio, natural moisture content, settlement, compression ratio, one-dimensional consolidation.
- Abstract
-
Agricultural insecurity from wildlife encroachment and crop raiding threatens food production in Sub-Saharan Africa (SSA), where 60% of smallholder farmers rely on agriculture. Conventional barbed wire and electric fences are passive, static, and poorly suited for rural SSA's resource-constrained environments. This paper presents a systematic review of smart fence technologies for real-time farm protection, adhering to PRISMA 2020 guidelines. From an initial 1,247 documents across IEEE Xplore, ScienceDirect, SpringerLink, and Google Scholar, 56 peer-reviewed studies (2008–2026) were selected for synthesis following title and abstract screening, duplication, and full-text eligibility assessment. The review classifies smart fences into four categories: sensor-based, vision-based, IoT-based, and hybrid AIoT-based. Under controlled conditions, YOLOv8 models outperformed others with over 92% detection accuracy. For edge deployments, MobileNetV3 achieved 85.7% accuracy on commodity hardware, consuming only 3.1 W. Critically, the study found no smart fence deployments in the literature validated specifically for SSA, highlighting a major gap given the region's unique infrastructural challenges. Key contributions of this paper include: (i) synthesizing AI and smart fence performance benchmarks; (ii) establishing a 12-factor matrix quantifying SSA deployment constraints by severity, prevalence, and technology readiness; (iii) proposing an SSA-specific edge-AI reference architecture optimized for solar power, low connectivity, and a sub-$400 deployment cost; and (iv) outlining a structured 3-level research roadmap aligned with TRL 4-9 milestones. This review provides a solid foundation for developing cost-effective, context-aware smart fencing tailored to SSA's agricultural realities.
- References
- Downloads
- Published
- 08-09-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Omokhafe J. TOLA, James G. AMBAFI, Umar S. DAUDA (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Bala I. ABDULKARIM, Yusuf M. BABA, Suleiman I. ENEHE, Kamoru A. SALAM, Umar IDRISS, Synthesis of Activated Carbon from Corncob for the removal of Lead (Pb²⁺) ions from Aqueous solution using a packed bed Adsorption Column , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Sirajo ALHASSAN, Abdullahi A. ADAMU, Mohammed T. JIMOH, Experimental Characterization and Seasonal Energy Potential Assessment of Municipal Solid Waste in Kano City, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Sarafa ISHOLA, Olusegun S. OLAOYE, Adeyinka A. ADEGBOLA, Isaac A. OLUREMI, Oluseye O. AGBEDE, Drying Kinetics and Combustion Characteristics of Carbonized Cashew Nut Shell Briquettes Under Open Sun, Passive and Active Solar Drying , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Mordecai C. EZEALOR, Bosede A. ORHEVBA, Ruth O. OYEBAMIJI, Quality Evaluation of Yogurt Produced from Chili Pepper-Derived Starter Culture , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Jamesmary E. AYANRU, Matthew S. ABOLARIN, Omotayo I. OGUNWEDE, Henry I. MORKAH, Adeshola O. OPENIBO, Development and Performance Evaluation of a Dryer for Preserving Vegetable Leaves , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Nafisa A. ABDULHAMID, Danladi D. USMAN, Kabiru I. JAHUN, Rotkangmwa J. SATI, Yahaya U. JAURO, Abdulmajid M. HASHIR, Yusuf G. SHIMBURA, Development of a Solar Dryer with Multi-Products and a Residual Moisture Control System , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Sati C. NSHOL, Saeed Y. UMAR, Suleiman A. YERO, Modification of the Engineering Properties of Road Base Course Soil Materials with Cement and Polyethylene Terephthalate (PET) , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Victoria A. UMEJURU, Isaac E. IHUA-MADUENYI, Adaobi S. NWOSI-ANELE, Performance Evaluation and Economic Assessment of Electrical Submersible Pumps for Heavy Oil Production in Mature Niger Delta Oilfields , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Koliya LAAYE, Solomon O. OGUCHE, Ibrahim I. JIDDA, Abdullahi A. ADAMU, Economic Viability of Waste-to-Energy: Pathways for Sustainable Power Generation in Jalingo, Taraba State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Olusiji A. ADEYANJU, Joseph O. OLAIDE, Machine Learning Models for Predicting Flow Rate for Niger Delta Oil Wells , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Omokhafe J. TOLA, Garba AMBAFI, Emmanuel C. OBUAH, Isah N. ABUBAKAR, Mutiat S. YISA, Development of Energy-Aware Hamiltonian-Based Fixed-Time Chaos Control and Synchronisation of Brushless DC Motor for Electric Vehicle Application , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
