Application of Integrated Solar-Powered Ultraviolet Radiation and Sand Biofiltration Techniques in Rural Water Treatment: A Review
- Authors
-
-
Sindrella AWINO
Author
-
Peter ADEOYE
Author
-
- Keywords:
- Biofiltration; poultry and abattoir effluent; rural water treatment; solar power; UV-C disinfection; waterborne diseases.
- Abstract
-
Access to clean water is still an issue all over the world, and in the context of rural and peri-urban areas of sub-Saharan Africa, it is a matter of grave concern due to widespread contamination of shallow wells and surface water resources by sewage from abattoirs and poultry farms. Commonly available technological solutions for rural water treatment are often very costly, energy-intensive, and technically demanding. This paper reviews the prospects of using sand-based biofiltration (bio-sand filtration) in combination with solar ultraviolet-C (UV-C) disinfection as a multi-barrier engineering solution to access safe water in rural Africa. The basics of sand-based biofiltration, including principles of schmutzdecke formation, pathogen removal kinetics, and hydraulic design are covered together with the basics of photochemical action of UV-C radiation, its dosimetry and limitations due to turbidity. The current state of development of engineering designs was reviewed, particularly the Centre for Affordable Water and Sanitation Technology (CAWST) Version 10 bio sand filter, biologically active carbon media in filters, and sizing solar photovoltaic (PV) power systems to operate UV lamps. Pilot field tests have demonstrated that the technology allows achieving more than 99.99% removal efficiency of bacteria, reduction of turbidity down to 1 NTU, and 40 mJ/cm² irradiance using a 10-16 W lamp and a 100 W PV module. Problems and perspectives of the application of the technology in Uganda with respect to water scarcity, industrial pollution, availability of solar radiation, and appropriate-technology infrastructure are discussed. This paper discusses the potential of Bio-sand filtration (BSF) with solar UV-C disinfection in terms of advancement of Sustainable Development Goal (SDG) 6 in rural Uganda.
- References
- Downloads
- Published
- 14-08-2026
- Section
- Articles
- License
-
Copyright (c) 2026 Sindrella AWINO, Peter ADEOYE (Author)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Hafsah A. ABDULRAHMAN, Muhammad M. HAMIDU, Techno-Economic Optimization of a Hybrid PV-Wind-Waste-to Energy System for the University of Maiduguri , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Obafemi A. IBITOYE, Jemimah O. TOLU-ALALADE, Solar-Powered Low-Cost Housing: Designing Off-Grid Communities with Interlocking Stabilised Soil Blocks (ISSB) , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Taiwo J. DURODOLA, Suleiman ZUBAIR, James AGAJO, Open Radio Access Network (ORAN) Deployment Strategies for Remote Areas , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Nuhu MOHAMMED, Garkuwa Y. ADAMU, Abubakar A. FACHWAY, Aminu MOHAMMED, Afolayan A. OLASUNKANMI, Odoh F. CHIMEZIE, Muhammad A. YUSUF, Development of A Water-Recycling Pico Hydropower System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Yetunde M. ALADEITAN, Abdulmojeed O. OLUOGUN, Potential of Zinc Oxide Nanoparticles for Remediation of Oil-Contaminated Soil and Water , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Francis O. BOROKINNI, Olarewaju T. OGINNI, Ridwan O. RAJI, Kolawole ALONGE, Effects of Quenching Media and Heat Transfer Rate on the Hardness and Microstructure of Low-Carbon Steel , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Mu’azu ABUBAKAR, Abubakar B. ALIYU, Dauda GARBA, Fabrication, Characterization, and Application of Clay-Based Ceramic Membranes for Oily Wastewater Treatment: A Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Muhammad M. HAMIDU, Mathew KATAMBI, Omar FARUQ, Techno-Economic and Environmental Assessment of a Solar PV-Based Microgrid for Residential Electrification in Gwange I, Maiduguri Using HOMER Pro , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Jafaru A. MOHAMMED, Thomas N. GUMA, Malachy SUMAILA, Mahdi MAKWAYO, A Review of Local Manufacturing of Borehole Windmill Gear Trains Using Reverse Engineering and Integrated Braking Systems , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Bala I. ABDULKARIM, Phebe O. JAMES, Utilization of Microbial Fuel Cells for Electricity Generation from Gwagwalada Abattoir Wastewater , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
