Experimental Study on the Characterisation and Thermo-Physical Properties of Graphene-Agro Based Hybrid Nanofluids
- Authors
-
-
Chukwuemeka S. IBEH
Author
-
Abubakre O. KAMARDEEN
Author
-
Saka A. ABDULKAREEM
Author
-
Aliyu A. ABDULLAHI
Author
-
- Keywords:
- Graphene, Rice husk ash, Nanofluids, Thermal conductivity, Viscosity, specific heat capacity.
- Abstract
-
Over the decade, researchers have developed new nanofluids for heat transfer applications. Little or no reports are made with the use of Agro-waste products as nanofluids. The sole purpose of this study is to evaluate the potential of nanoparticles (rice husk ash and graphene) in the thermo-physical enhancement of nanofluid for heat transfer applications. The study also highlights the synthesis of rice husk ash-graphene nanoparticles and the preparation of nanofluids. Particle characterisation was conducted using techniques such as SEM/EDXRF, XRD and TGA/DTA. Thermal conductivity, viscosity and heat capacity of the nanofluid were investigated for different particle concentration (0.1, 0.3 and 0.5wt.%) at temperatures (50, 60 and 70oC) with deionized water as base fluid. The examine nanofluids shows better stability, an average maximum thermal conductivity enhancement of 71% at 70oC and 0.5wt.% concentration for hybrid nanofluid. The excellent thermal properties of the nanofluids make them suitable candidates as nanofluids for heat transfer application.
- References
- Downloads
- Published
- 23-05-2026
- Section
- Articles
- License
-
Copyright (c) 2026 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Benjamin T. ABUR, Abubakar A. WARA, David ISAH, Mary D. IGBUR, Catherine N. KWAGHMANDE, Co-Gasification of Sugarcane Bagasse and Coal: A Study on Thermal Characteristics and Efficiency , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Jamesmary E. AYANRU, Matthew S. ABOLARIN, Omotayo I. OGUNWEDE, Henry I. MORKAH, Adeshola O. OPENIBO, Development and Performance Evaluation of a Dryer for Preserving Vegetable Leaves , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Bosede A. ORHEVBA, Sodeeq A. OLAJIDE, Optimization of Alkaline Pretreatment and Fermentation Conditions for Improved Physicochemical Properties and Yield of Bioethanol Produced from Sugarcane Bagasse , FUDMA Journal of Engineering and Technology: Vol. 1 No. 1 (2025): July 2025
- Mohammed A. GANA, Zaka A. MSHELIA, Isuwa S. AJI, Alhaji GUJJA, Lawan A.M. KOLO, Investigation and Comparative Analysis of Natural Moulding Sands from Five Deposits in Maiduguri, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Oluwaseun S. OGUNGBEMI, Aquifer Characterisation and Vulnerability Assessment in a Typical Basement Complex Terrain , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Obafemi A. IBITOYE, Jemimah O. TOLU-ALALADE, Solar-Powered Low-Cost Housing: Designing Off-Grid Communities with Interlocking Stabilised Soil Blocks (ISSB) , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Martins Y. OTACHE, Iyanda M. ANIMASHAUN, Sadeeq A. MOHAMMED, Emmanuel O. AGBESE, Spatiotemporal Variability and Trend Analysis of Rainfall and Temperature in Northern Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 1 (2025): July 2025
- Sulaiman Y. ADAMU, Fadimatu N. DABAI, Abdulazeez Y. ATTA, Baba Y. JIBRIL, Preparation and Characterization of Enhanced Hierarchical Zn-Ni/HZSM-5 Catalysts for Potential use in Catalytic reactions to Upgrade Bio-Oil and Hydrogen from Biomass Pyrolysis , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Bala ABDULLAHI, Bala G. ABDURRAHMAN, Yusuf ALHASAN, Saidu B. ABUBAKAR, Bashir I. KUNYA, Raya K. ALDADAH, Saad MAHMOUD, Ahmed REZK, Effects of Truncating the Height of Compound Parabolic Collector on its Geometry, Optical and Thermal Performances , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Bala I. ABDULKARIM, Yusuf M. BABA, Suleiman I. ENEHE, Kamoru A. SALAM, Umar IDRISS, Synthesis of Activated Carbon from Corncob for the removal of Lead (Pb²⁺) ions from Aqueous solution using a packed bed Adsorption Column , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
