Cross-Regional Energy Strategies: Evaluating Japan’s Power Blueprint for Nigeria’s Needs
- Authors
-
-
Mutiat S. YISA
Department of Electrical and Electronics Engineering, Federal University of Technology, Minna, Nigeria
Author
-
- Keywords:
- Energy strategy, renewable energy, nuclear power, Nigeria, Japan energy mix.
- Abstract
-
The urgent need for sustainable, secure, and diversified energy sources remains a pressing concern for both developed and developing economies. Japan, an advanced economy with limited domestic energy resources, has adopted a power generation strategy centered around nuclear energy, liquefied natural gas (LNG), and wind. Conversely, Nigeria, a resource-rich yet energy-deficient country, continues to struggle with energy access and sustainability. This paper conducts a comparative assessment of Japan's proposed power generation strategy and evaluates its viability and applicability in the Nigerian context. Using criteria such as economic feasibility, environmental sustainability, energy security, and socio-political acceptability, the study finds that adapting elements of Japan’s strategy, particularly its emphasis on LNG, nuclear, and wind, could significantly enhance Nigeria’s energy mix. However, key contextual differences such as geography, regulatory maturity, infrastructure, and public perception must be carefully considered for successful policy transfer.
- References
- Downloads
- Published
- 08-08-2025
- Section
- Articles
- License
-
Copyright (c) 2025 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Nsikan L. AKPAN, Akaniyene OBOT, Olusegun A. AFOLABI, Improvement of Power Efficiency of Sensor Network Using Ant Colony Optimization and K-Means Clustering Technique , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Muhammad B. MUHAMMAD, Muhammad Y. ABDULLAHI, Aminu BALA, Optimal Reduction of Technical Power Losses in Radial Distribution Networks Using Differential Evolution for Distributed Generation: A Case Study of the Azare Substation in Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Abubakar M. ALI, Haruna IBRAHIM, Ephraim G. KEFAS, Thermal Plasma Gasification of Municipal Solid Waste: Principles, Technological Advances, Challenges, and Future Prospects , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Omokhafe J. TOLA, Garba AMBAFI, Emmanuel C. OBUAH, Isah N. ABUBAKAR, Mutiat S. YISA, Development of Energy-Aware Hamiltonian-Based Fixed-Time Chaos Control and Synchronisation of Brushless DC Motor for Electric Vehicle Application , FUDMA Journal of Engineering and Technology: Vol. 2 No. 2 (2026): December 2026
- Sirajo ALHASSAN, Abdullahi A. ADAMU, Mohammed T. JIMOH, Experimental Characterization and Seasonal Energy Potential Assessment of Municipal Solid Waste in Kano City, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Emmanuel T. ODEYEMI, Ya’u S. HARUNA, Ganiyu A. BAKARE, Hassan B. MAMMAN, Sabo M. HASSAN, BAT-Optimized PID and ANFIS Torque-Based MPPT for a 0.5 MW PMSG-Based Wind Energy Conversion System Under Dynamic Wind Conditions , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Obafemi A. IBITOYE, Jemimah O. TOLU-ALALADE, Solar-Powered Low-Cost Housing: Designing Off-Grid Communities with Interlocking Stabilised Soil Blocks (ISSB) , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Adekunle O. ADEWOLE, Ayodeji O. ARIYO, Development of an Edge-Enabled IoT Smart Energy Meter with Artificial Intelligence (AI)-Based Load Prediction for Device-Level Monitoring , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Muhammad M. HAMIDU, Development of MATLAB-Based Model for Solar Radiation Prediction and Photovoltaic Panel Tilt Optimization Angle for Maiduguri Region, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Abdulkarim AMINU, Mohammed ALIYU, Ibrahim S. MOHAMMED, Iyanda M. ANIMASHAUN, Peter DANIEL, Mohammad USMAN, Production and Optimisation of Parameters for Density and Ash Content of Briquettes Produced from Sorghum Stalks and Groundnut Shells Using African Locust Bean (Parkia biglobosa) Pulp as a Binding Agent , FUDMA Journal of Engineering and Technology: Vol. 1 No. 1 (2025): July 2025
You may also start an advanced similarity search for this article.
