Experimental Characterization and Seasonal Energy Potential Assessment of Municipal Solid Waste in Kano City, Nigeria
- Authors
-
-
Sirajo ALHASSAN
Author
-
Abdullahi A. ADAMU
Author
-
Mohammed T. JIMOH
Author
-
- Keywords:
- Calorific value; Energy recovery; Municipal solid waste; Seasonal variation; Waste-to-energy.
- Abstract
-
Municipal solid waste (MSW) management remains a critical environmental challenge in rapidly urbanizing regions such as Kano City, Nigeria. This study presents an experimental characterization and energy potential assessment of MSW based on seasonal variation (dry and wet seasons). Representative samples were collected from four major dumping sites: Sallari, Maimalari, Uba Gama, and Hajj Camp. Proximate and ultimate analyses were conducted to determine moisture content, ash content, volatile matter, fixed carbon, and elemental composition (C, H, O, N, and S). The results reveal clear seasonal differences in MSW properties. Moisture content ranged from ≈28.25% in the dry season to ≈44.25% in the wet season, while ash content varied between ≈28.50% and ≈31.50%. Volatile matter increased from ≈19.75% in the wet season to ≈28.40% in the dry season, and fixed carbon ranged from ≈4.50% to ≈14.85%. Ultimate analysis revealed relatively stable elemental composition across seasons, with carbon (≈45.57–46.23%), hydrogen (≈6.49–6.58%), oxygen (≈45.31–46.31%), nitrogen (≈1.42–1.43%), and sulfur (≈0.23–0.24%). These results indicate moderate fuel characteristics with variability influenced by seasonal conditions. The higher heating value (HHV) was estimated to range between ≈16.43 and ≈16.95 MJ/kg, while the lower heating value (LHV) ranged from ≈13.92 to ≈14.82 MJ/kg, with higher values observed during the dry season due to reduced moisture content. The findings suggest that although high moisture and ash contents may limit the efficiency of direct combustion, the waste stream possesses moderate energy recovery potential. Overall, the findings confirm the suitability of MSW in Kano City for thermochemical conversion technologies such as pyrolysis and gasification, particularly with appropriate pre-treatment strategies. This study provides robust, seasonally resolved experimental data for supporting sustainable waste-to-energy planning and decision-making in rapidly growing urban environments.
- References
- Downloads
- Published
- 13-04-2026
- Section
- Articles
- License
-
Copyright (c) 2026 FUDMA Journal of Engineering and Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Similar Articles
- Mukhtar N. YAHYA, Sohaib ALHAJHUSSEIN, Wastewater Analysis Using Kubota Membrane Bioreactor System , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Mohammed U. GARBA, Musa A. ABDULLAHI, Isah RABI, Saadatu A. GORO, Habibu UTHMAN, Abubakar S. MOHAMMED, Umaru AHMADU, Usman S. ONODUKU, Recovery of Lithium Carbonate from Nigerian Lepidolite Ore via Roasting-Leaching-Precipitation , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Jamesmary E. AYANRU, Matthew S. ABOLARIN, Omotayo I. OGUNWEDE, Henry I. MORKAH, Adeshola O. OPENIBO, Development and Performance Evaluation of a Dryer for Preserving Vegetable Leaves , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Salisu MOHAMMED, Abdulfatai JIMOH, Abdullahi M. EVUTI, Abdulwahab GIWA, Abubakar A. IBRAHIM, Pretreatment and Characterization of Selected Precursors for Chitin/Chitosan Production , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Lucas A. J. HAMIDU, Microscopic Characterization of Optimized Particleboards Made from Softwood Sawdust and Rice Husk Using Optimized Polystyrene Waste Adhesive , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Mutiat S. YISA, Cross-Regional Energy Strategies: Evaluating Japan’s Power Blueprint for Nigeria’s Needs , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Chinemeogo C. OZIOKO, Ikechukwu C.-E. IKE-EZE, Nnanyelugo O. EDWIN, Dimelu K. EBUBE, Charles MBOHWA, Investigation of the Mechanical and Thermal Properties of Waste Toner Powder Reinforced Polyester Composite for Industrial Applications , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
- Victor A. NSABA, Sabiu B. YUSUF, Kafayat A. IBRAHIM, Consumer Perceptions of Artificial Intelligence (AI)-Driven Smart Grids and Energy Efficiency in Northwest Nigeria’s Power Distribution Sector: A Multi-State Case Study of Sokoto, Kebbi, and Zamfara , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Umar A. ADAMU, Ya’u S. HARUNA, Ganiyu A. BAKARE, Buhari H. MAMMAN, Kunduli MUSTAPHA, Hadi M. ADAMU, Ismaila MAHMUD, Design and Simulation of a 200 MWp Floating Solar PV Plant Integrated with the Kainji Hydropower Plant, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Adekunle O. ADEWOLE, Ayodeji O. ARIYO, Development of an Edge-Enabled IoT Smart Energy Meter with Artificial Intelligence (AI)-Based Load Prediction for Device-Level Monitoring , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
You may also start an advanced similarity search for this article.
Most read articles by the same author(s)
- Sirajo ALHASSAN, Abdullahi A. ADAMU, Mohammed T. JIMOH, Multi-Criteria Decision Analysis and Optimization Approaches in Sustainable Waste-to-Energy Planning: A Systematic Review , FUDMA Journal of Engineering and Technology: Vol. 2 No. 1 (2026): June 2026
- Koliya LAAYE, Solomon O. OGUCHE, Ibrahim I. JIDDA, Abdullahi A. ADAMU, Economic Viability of Waste-to-Energy: Pathways for Sustainable Power Generation in Jalingo, Taraba State, Nigeria , FUDMA Journal of Engineering and Technology: Vol. 1 No. 2 (2025): December 2025
